Abstract:Abstract The feasible resolution of angular displacement measurement by an optical angle sensor based on laser autocollimation is investigated. Improving the sensor sensitivity while maintaining the noise level of the sensor signal as low as possible is necessary to achieve high-resolution angular displacement measurement. In this paper, the contribution of each component, such as a photodiode, a trans-impedance amplifier, and an analog-to-digital converter in the optical angle sensor, to the noise level of the sensor signal is first estimated on the basis of theoretical equations. The feasible sensitivity of the optical angle sensor is also estimated in numerical calculations. The sensitivity of a photodiode element at the edge of its photosensitive area is evaluated in experiments to realize the estimation of the angle sensor sensitivity. Experimental results are applied to the numerical calculations. The influences of the measurement laser beam diameter, the spot diameter of the focused laser beam on the photosensitive area, and the focal length of the collimator objective of the optical angle sensor are also considered in the numerical calculations. Finally, a prototype optical setup is developed. Experiments are performed to demonstrate that a compact optical angle sensor based on laser autocollimation with a collimator objective having a focal length shorter than 100 mm can achieve a resolution beyond 0.001 arc-second with a bandwidth of 1 kHz. This resolution is better than those achieved by commercial autocollimators employing an image sensor or a position-sensitive detector. The industrial contribution of this paper lies in the detailed breakdown of noise components in the readout signal of an angle sensor in a practical condition and the systematic estimation of its feasible resolution as well as its sensitivity.

A Laser Walk-off Sensor for High-Precision Low-Frequency Rotation Measurements.

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Research on high-speed and non-contact angle detection based on laser measurement

Ultra-sensitive angle sensor based on laser autocollimation for measurement of stage tilt motions

Ultra-precision angle sensor with a mode-locked laser source

1506 Determination of the origin position for an angle sensor with a femtosecond laser

Determination of the Zero-Position for an Optical Angle Sensor

Highly Sensitive Lateral Deformable Optical MEMS Displacement Sensor: Anomalous Diffraction Studied by Rigorous Coupled-Wave Analysis.

Single-Element Dual-Interferometer for Precision Inertial Sensing: Sub-picometer Structural Stability and Performance as a Reference for Laser Frequency Stabilization

A Precision Angle Sensor using an Optical Lever inside a Sagnac Interferometer

High-resolution compact displacement sensor based on anisotropic feedback of microchip Nd: YAG lasers

A High-Precision Five-Degree-Of-Freedom Measurement System Based on Laser Collimator and Interferometry Techniques

Feasible Resolution of Angular Displacement Measurement by an Optical Angle Sensor Based on Laser Autocollimation

Quasi-monolithic Compact Interferometric Sensor Head Design with Laser Auto-alignment

High-precision laser beam lateral displacement measurement based on differential wavefront sensing

High Sensitivity and Full-Circle Optical Rotary Sensor for Non-Cooperatively Tracing Wrist Tremor With Nanoradian Resolution

Quasi-monolithic heterodyne laser interferometer for inertial sensing

Optimal alignment sensing of a readout mode cleaner cavity

A Displacement Sensor Combining Cavity Tuning of A Laser with A Piezoelectric Transducer'S Subdivision Technique for A Bidirectional Sampling on the Rising and Falling Flanks

Displacement Sensors Based on Feedback Effect of Orthogonally Polarized Lights of Frequency-Split Hene Lasers

Displacement Sensor Based on Intra-Cavity Tuning of Dual-Frequency Gas Laser