Abstract:Carbon fiber reinforced polymer (CFRP) composites are widely used in the aerospace field because of their outstanding performance. Short pulse laser is an effective means for efficient and high-quality cutting of CFRP. However, the inevitable thermal effect of laser processing results in damage such as heat-affected zone, and the exposed area of fiber loses the ability to transmit force, which weakens the mechanical properties of CFRP. However, the effect of thermal damage on mechanical properties is complex. In this paper, the dynamic and static mechanical behavior of short pulse laser cutting CFRP is studied, and the effect of cutting damage on the mechanical properties is explored. The mechanical properties of CFRP plate hole laser cutting is similar to those of mechanical drilling but are lower than those of material without hole due to the existence of holes. Matrix cracking exists in the tensile fatigue of laser cutting holes, while surface cracks occur in the stress-concentrated area due to the not smooth cutting edge of mechanical drilling. Compared with small laser cutting damage, the tensile and bending strength of the CFRP plate were weakened by 11.5% and 6.2%, respectively. The tensile fatigue crack propagation and fiber protrusion are aggravated by large damage. The damage always starts at both sides of the vertical direction of the hole under 0 ° laying, resulting in cracks along the fiber axis until fracture. The failure mode and fracture cross-section morphology are mainly fiber tears and delamination, and the section of the 90 ° laying specimen surface is tidier than that of the 0 ° laying specimen. The mechanical properties under thermal damage studied in this paper will help to lay a foundation for damage suppression and improvement of material mechanical properties.

Experimental study on CFRP drilling with the picosecond laser "double rotation" cutting technique

Dual-Method Characterization and Optimization of Drilling Parameters for Picosecond Laser Drilling Quality in CFRP

Study on Robot Automatic Drilling of Carbon Fiber Reinforced Plastics (CFRP)

Machining holes in CFRP with laser "drilling + boring" hybrid technique

Femtosecond Laser Drilling of Cylindrical Holes for Carbon Fiber-Reinforced Polymer (CFRP) Composites

Helical drilling of carbon fiber reinforced polymer by a femtosecond laser

Investigation of Heat Accumulation in Femtosecond Laser Drilling of Carbon Fiber-Reinforced Polymer

Experimental Study on Carbon Fiber-Reinforced Composites Cutting with Nanosecond Laser

Hole Quality and Thermal Defects in Drilled CFRP by Nanosecond Pulsed Laser

Comparative investigations on machinability and surface integrity of CFRP plate by picosecond laser vs laser induced plasma micro-drilling

Improving hole quality of thick CFRP laminates through a laser-mechanical compound drilling process

Investigations on 355 nm picosecond laser machining of carbon fiber reinforced polymer composites

Understanding factors affecting the process efficiency, quality and carbon emission in laser drilling of CFRP composite via tailored sequence multiple-ring scanning

Effect of thermal damage on dynamic and static mechanical properties of CFRP short pulse laser hole cutting

Reducing the taper and the heat-affected zone of CFRP plate by Micro fluid assisted laser induced plasma micro-drilling

Effect of scanning spacing on the efficiency of CFRP hole-cutting with multi-pass scanning strategy by nanosecond laser

Drilling of CFRP plates with adjustable pulse duration fiber laser

Hole quality in longitudinal–torsional coupled ultrasonic vibration assisted drilling of carbon fiber reinforced plastics

Experimental study on the sidewall quality of femtosecond laser drilling CFRP

Investigation on heat transfer and ablation mechanism of CFRP by different laser scanning directions

Experimental study on the hole machining process of a newly developed AFRP/Al/AFRP co-cured material: A comparative analysis of milling and drilling