Abstract:In order to improve the ability of the modular multi-level converter to quickly clear and isolate faults in the multi-terminal flexible DC grid, this paper analyzes the characteristics of current faults in the multi-terminal flexible direct current grid, introduces the comprehensive distance of current fault waveform, and proposes a line protection method based on the similarity of current fault waveform. This protection method firstly uses Euclid Dynamic Time Warping (DTW) distance and entropy weight method to process electrical quantity signals, calculates the comprehensive distance of current fault waveform of two converter stations, and builds the protection criterion based on the similarity of current fault waveform. Then, the fault identification is realized by using the calculated comprehensive distance, and the fault pole identification is realized by using the ratio of comprehensive distance between positive and negative poles. Finally, PSCAD was used to build a simulation model to output the fault data under different fault conditions, and MATLAB was used to process the fault data to verify the protection algorithm. The simulation results show that the proposed method has good resistance to high resistance, and its rapidity and adaptability are further improved. Compared with other similarity methods, this method combines Euclidean DTW distance and entropy method to process the signal, realizes the fault pole identification, and can still operate correctly under the interference of 500 & omega; transition resistance and 20 dB noise ratio. The research results will provide a theoretical basis for the safe and reliable operation of flexible DC power grid. This paper analyzes the characteristics of current faults in the multi-terminal flexible direct current grid, introduces the comprehensive distance of current fault waveform, and proposes a line protection method based on the similarity of current fault waveform.image

Single-end Fault Identification Scheme for Multi-Terminal DC Grid Based on Amplitude Similarity of Injection Signal

Fault Identification Scheme for Protection and Adaptive Reclosing in a Hybrid Multi-Terminal HVDC System

Fault Properties Identification Scheme for Hybrid MTDC System Based on LCC Signal Injection and Distributed Parameter Line Model

Active Injection for Single-Ended Protection in DC Grid Using Hybrid MMC

Single-ended active injection for fault location in hybrid MMC-HVDC systems

Fault Property Discrimination Scheme in Hybrid MTDC Power System Based on the Amplitude Distribution of Injection Signal

A Single-Ended Fault Location Method for DC Line Based on Active Signal

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

A DC Fault Identification Scheme for Multi-Terminal VSC-LVDC System Based on Voltage of Current-Limiting Reactor

DC Line Fault Identification Based on Pulse Injection from Hybrid HVDC Breaker

A Fault Identification Method for HVDC Transmission Lines Based on Waveform Characteristic of Specific Frequency Current

A Modified DC Fault Protection Scheme for Multi-Terminal HVDC Grid Based on Fault Current Limiters

Adaptive AC Autoreclosing Scheme in MMC‐based Hybrid AC/DC Transmission

Permanent Fault Identification and Location Scheme for MTDC Grid Based on Equivalent Impedance Phase Characteristics and Distributed Parameter Line

Adaptive Single-Terminal Fault Location for DC Microgrids

Identification and Isolation of Faults in Multi-terminal High Voltage DC Networks with Hybrid Circuit Breakers

A Novel Single-Terminal Fault Location Method for AC Transmission Lines in a MMC-HVDC-Based AC/DC Hybrid System

A Faulty Feeder Selection Method for SLG Faults Based on Active Injection Approach in Non-Effectively Grounded DC Distribution Networks

Single-ended DC Fault Location Method For MMC-Based HVDC Power System Using Adaptive Multi-step Levenberg-Marquardt Algorithm

Adaptive Single-Pole Auto-Reclosing Scheme for Hybrid MMC-HVDC Systems

New pilot protection method based on the current fault component waveform similarity