Abstract:In this study, the effects of Si content on the glass-forming ability (GFA), thermal stability, annealing window, nanocrystallization process, and soft magnetic properties (SMPs) of Fe 86.3-x Si x B 10 P 2 Cu 1.7 (x = 0, 1, 2, 3, and 4, denoted as Si0, Si1, Si2, Si3, and Si4, respectively) alloys with high Fe and Cu contents were investigated. Moderate addition of Si (x = 1, 2, and 3) enhanced the GFA and suppressed the precipitation of compound phases, thus leading to a large crystallization temperature interval ( ΔT x ) exceeding 185 °C for the alloys. Appropriate addition of Si also resulted in the formation of high-density and fine pre-existing α-Fe nanocrystals in as-spun ribbons and a high growth active energy of α-Fe crystals during the subsequent nanocrystallization process for the Si1, Si2, and Si3 alloys, enhancing competitive growth between α-Fe crystals and resulting in fine nanostructure and excellent SMPs of the nanocrystalline alloys (NAs). As a result, the Si1, Si2, and Si3 NAs obtained by annealing at 420 °C for 30 min exhibited excellent SMPs with saturation magnetic flux density ( B s ) up to 1.84 T and a low coercivity ( H c ) of approximately 10 A/m. In addition, statistical analysis of the relationship between the average grain size ( D ) of α-Fe crystals and H c values of the NAs indicated that an H c α D 3 dependence is observed when the D is less than approximately 30 nm, while this dependence follows the well-known H c α D 6 relationship when the D is above 30 nm. The dependency relationship between D and H c of NAs can guide the selection of an appropriate annealing process to optimize their SMPs.

Origin of the Separated Α-Al Nanocrystallization with Si Added to Al86Ni9La5 Amorphous Alloy

Thermal Stability and Crystallization Behavior of Al86Ni9Y5 Amorphous Alloys with Different Si Addition

The Crystallization Kinetics Study of Finemet-Co Amorphous Alloys

The Crystallization of Cr–Si–Ni–Al Amorphous Films—nucleation and Growth of Intermetallic Phase Cr(Al,Si)2

Crystallization of Bulk Amorphous Alloy (Fe40ni40p14b6)(96)ga-4 in Supercooled Liquid Region

Insights into the structure sustainable evolution and crystallization kinetics of amorphous Mg60Ni30La10 alloy

Nanocrystallization Kinetics of Amorphous Fe73.5Cu1Nb3−xMoxSi13.5B9 (x=1, 2, 3) Alloys

Atomic level simulation of amorphous/nanocrystalline transition behavior in the Fe based amorphous alloys

Annealed Crystallization of Ultrafine Amorphous NiB Alloy Studied by XAFS.

Phase stability and the interface structure of a nanoscale Si crystallite in Al-based alloys

Formation and Crystallization Behavior of Fe-based Amorphous Precursors with Pre-Existing Α-Fe Nanoparticles—structure and Magnetic Properties of High-Cu-content Fe-Si-B-Cu-Nb Nanocrystalline Alloys

Structure and phase transformations of amorphous-nanocrystalline Al-based alloy

Nanoscale Phase Separation and Local Icosahedral Order in Amorphous Alloys of Immiscible Elements

Effects of La content on the glass transition and crystallization process of Al–Ni–La amorphous alloys

Formation of an Intermetallic Phase by Crystallization in the Cr–Si–Ni–Al Amorphous Film

Dependences of the Crystallization Behavior of Al–Ni–La Amorphous Alloys on La and Ni Contents

Experimental Investigation on Recrystallization Mechanism of a Ni-base Single Crystal Superalloy

The Role of Aluminum in the Crystallization of Cr–Si–Ni Resistive Films

Effects of Si addition on crystallization process and soft magnetic properties of high-Fe and high-Cu-content Fe-Si-B-P-Cu nanocrystalline alloys

Unusual alloying effects of Co and Ni on structure and magnetic properties of Fe-Si-B-Cu nanocrystalline alloys with pre-existing α-Fe nanocrystals

Uncovering the role of nanoscale Si particles on the thermal stability of a lamellar-nanostructured Al–1%Si alloy