Abstract:Subsurface damage (SSD) produced in a grinding process will affect the performance and operational duration of single-crystal silicon. In order to reduce the subsurface damage depth generated during the grinding process by adjusting the process parameters (added), experiments were designed to investigate the influence of machining factors on SSD. This included crystal orientation, diamond grit size in the grinding wheel, peripheral speed of the grinding wheel, and feeding with the intention to optimize the parameters affecting SSD. Compared with isotropic materials such as glass, we considered the impact of grinding along different crystal directions and on subsurface damage depth (added). The Magnetorheological Finishing (MRF) spot technique was used to detect the depth of SSD. The results showed that the depth of SSD in silicon increased with the size of diamond grit. SSD can be reduced by either increasing the peripheral speed of the grinding wheel or decreasing the feeding rate of the grinding wheel in the crystal orientation, if the same size of diamond grit was employed. In addition, we proposed a modified model around surface roughness and subsurface crack depth, which considered plastic and brittle deformation mechanisms and material properties of different crystal orientations. When the surface roughness (R-Z) exceeded the brittle-plastic transition's critical value R-ZC (R-ZC > 1.5 mu m, R-ZC > 0.8 mu m), cracks appeared on the subsurface. The experimental results were consistent with the predicted model, which could be used to predict the subsurface cracks by measuring the surface roughness. However, the model only gives the approximate range of subsurface defects, such as dislocations. The morphology and precise depth of plastic deformation subsurface defects, such as dislocations generated in the fine grinding stage, needed to be inspected by transmission electron microscopy (TEM), which were further studied.

An Analytical Model to Predict the Depth of Sub-Surface Damage for Grinding of Brittle Materials

Study on the Model of Surface Crack Depth in Ceramics Grinding

Analytical prediction for depth of subsurface damage in silicon wafer due to self-rotating grinding process

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Analytical Elastic–Plastic Cutting Model for Predicting Grain Depth-of-Cut in Ultrafine Grinding of Silicon Wafer

Models of grinding-induced surface and subsurface damages in fused silica considering strain rate and micro shape/geometry of abrasive

Optimization of grinding process for hard and brittle materials based on damage evolution mechanism

Analytical modeling of grinding-induced subsurface damage in monocrystalline silicon

Prediction of Grinding Induced Subsurface Damage of Optical Materials

An analytical force and energy model for ductile-brittle transition in ultra-precision grinding of brittle materials

Study of Prefabricated Crack Propagation on Monocrystalline Silicon Surfaces for Grinding Damage Analysis

Study on Subsurface Damage Model of the Ground Monocrystallinge Silicon Wafers

Model of Grain Depth of Cut in Wafer Rotation Grinding Method for Silicon Wafers

The Influence of Crystal Orientation on Subsurface Damage of Mono-Crystalline Silicon by Bound-Abrasive Grinding

Surface Micro-Morphology Model Involved in Grinding of GaN Crystals Driven by Strain-Rate and Abrasive Coupling Effects

Effect of grinding damage on cutting force and ductile machining during single grain scratching of monocrystalline silicon

Analysis on model of grain depth-of-cut of wafer rotational grinding

Surface Roughness Model of Ground 4H-SiC Considering Ductile and Brittle Removal

Subsurface Damage in the Monocrystal Silicon Grinding on Atomic Scale

The Influence of Subsurface Damage Depth on Fracture Strength of Ground Silicon Wafers

Sensitivity Analysis of the Surface Integrity of Monocrystalline Silicon to Grinding Speed with Same Grain Depth-of-cut