Abstract:Due to the excellent physical and chemical properties, carbon nanotubes show broad applications in a variety of fields such as composite materials, catalysis, energy, medicine and sensor. However, at present, the carbon nanotubes are mainly practically used in the form of powders. Carbon nanotube fibers can be prepared by the methods of chemical vapor deposition and/or dry spinning. However, the carbon source used in previous study mainly has single component, making the mechanical and electrical properties of carbon nanotube fibers still difficult to effectively meet the practical application requirements. It remains challenging to realize continuous preparation of high-performance carbon nanotube fibers. In this work, a new cycloalkane/ethanol mixing carbon source was designed to obviously promote the continuous growth process and properties of carbon nanotube fibers. After carefully optimizing the component ratio of decahydronaphthalene/ethanol in the precursor solution, and systematically optimizing reaction conditions such as catalyst content (ferrocene and thiophene), injection rate of the precursor solution, and the flow rate of carrier gas (argon and hydrogen), the continuous preparation of high-performance carbon nanotube fibers was realized. When the mass ratio of decahydronaphthalene to ethanol carbon source in precursor solution is 3:7, the high-performance carbon nanotube fibers can be continuously produced for a long time with a collection rate of 220 m/h. It shows improved mechanical and electrical properties compared with the carbon nanotube fiber prepared by using single ethanol carbon source. For instance, the tensile strength of carbon nanotube fiber is increased by more than 1 time (750 MPa). The carbon nanotube fiber has good flexibility and can shows stable mechanical properties after millions of bending cycles. The conductivity is increased by more than 4 times (4.8x10(3) S/cm), which can effectively meet the application requirements of fiber energy-storing devices. The application of carbon nanotube fibers in a fiber-shaped lithium-carbon dioxide battery is demonstrated with good electrochemical performance.

Overlong carbon nanotubes and preparation method thereof

Water-Assisted Preparation of High-Purity Semiconducting (14,4) Carbon Nanotubes

Influence of Mesoporous Materials on the Preparation of Carbon Nanotubes

Method for preparing ultra-long carbon nanotube by mobile constant temperature region method

A New Method to Fabricate Large Amount of Single-Walled Carbon Nanotubes

Method for producing Nano carbon tubes continuously and equipment

Method for preparing single walled and double walled carbon nanotubes based on layered dihydroxy metal hydroxide

Metal Nanotubes Prepared by a Sol–gel Method Followed by a Hydrogen Reduction Procedure

Continuous Preparation of High-performing Carbon Nanotube Fibers Based on Cycloalkane/ethanol Mixing Carbon Source

Coating carbon nanotubes with polymer in supercritical carbon dioxide.

Preparation of Carbon Nanotubes at the Surface of Fe/SBA-15 Mesoporous Molecular Sieve

Selective growth of semiconducting single-walled carbon nanotubes solely from carbon monoxide

Method for preparing minor diameter carbon nanotube array on surface of flaky material

Freon-CO2-assisted purification of single-walled carbon nanotubes

Correction to Growth of Half-Meter Long Carbon Nanotubes Based on Schulz–Flory Distribution

Preparation method of carbon nanotube-silicon composite cathode material

Preparation of carbon nanofibers by the floating catalyst method

Carbon fiber composite single carbon nano tube and its preparing method

High-strength carbon nanotube fibers with near 100% purity acquired via isothermal vacuum annealing

Preparation of highly pure double-walled carbon nanotubes

Preparation method of carbon nano tube enhanced copper-based composite material