Abstract:With the aim of better understanding the distribution of arsenic, 144 coal samples were collected from southwestern Guizhou, and the concentrations of arsenic were determined by atomic fluorescence spectrometry (AFS) and inductively coupled plasma mass spectrometry (ICP-MS). The content of arsenic varies from 0.3 ppm to 3.2 wt.%. In most coal samples, the arsenic content was lower than 30 ppm, which was close to a representative value of arsenic concentration of coal in China. Arsenic contents in 37 samples, which were from several small coal mines, were more than 30 ppm, among which only 16 samples were more than 100 ppm, and only a few samples contained more than 1000 ppm, which were very restricted and the coal seams were generally unworkable. Combustion of two kinds of high arsenic coal with and without CaO additive was studied in a bench scale drop tube furnace (DTF) to understand the partition and emission of arsenic in the process. The PM was size segregated by low pressure impactor (LPI) into 13 size stages ranging from 9.8 to 0.0281 μm. X-ray fluorescence spectrometry (XRF) was used to determine the chemical composition of the PM, and inductively coupled plasma atomic emission spectrometry (ICP-AES) was used to determine the arsenic content. A bimodal mode distribution of the PM was formed during coal combustion; the large mode (coarse particle) was formed at 4.0 μm, and the other mode (fine particles) was at about 0.1 μm. A middle mode was gradually obvious in high temperature for both of the two coal combustions, which may have been derived from coagulation and agglomeration of metal elements vapors. More gaseous arsenic was formed in 50% oxygen content than 20% oxygen content. Arsenic in sulfide is easier to vaporize than as arsenate. Along with the increasing temperature from 1100 °C to 1400 °C, the arsenic concentration in PM1 increased from 0.07 mg/N m3 to 0.25 mg/N m3. With the addition of the calcium based sorbent, the arsenic concentration in PM1 decreases sharply from 0.25 mg/N m3 to 0.11 mg/N m3. Thus, the calcium based sorbent is an effective additive to control the emission of arsenic during coal combustion.

Formation Mechanism of Arsenic-Containing Dust in the Flue Gas Cleaning Process of Flash Copper Pyrometallurgy: A Quantitative Identification of Arsenic Speciation

Strategies for arsenic pollution control from copper pyrometallurgy based on the study of arsenic sources, emission pathways and speciation characterization in copper flash smelting systems

Formation of Arsenic−copper-Containing Particles and Their Sulfation Decomposition Mechanism in Copper Smelting Flue Gas

Reaction Mechanism and Distribution Behavior of Arsenic in the Bottom Blown Copper Smelting Process

Dissociation Mechanism of Particulate Matter Containing Arsenic and Lead in Smelting Flue Gas by Pyrite

Efficient removal and recovery of arsenic from copper smelting flue dust by a roasting method: Process optimization, phase transformation and mechanism investigation

Arsenic removal from acid extraction solutions of copper smelting flue dust

Distribution and Speciation Transformation of Hazardous Trace Element Arsenic in Particulate Matter of a Coal-Fired Power Plant

Performance and Mechanism of Arsenic-Metal Separation in Copper Smelting Flue Gas Regulated by Chalcopyrite

Mineralogical transformation of arsenic at different copper smelting workshops: The impact on arsenic bioaccessibility

Arsenic Emission of High-Arsenic Coal Combustion from Southwestern Guizhou,China

Determination of occurrence and leaching toxicity of arsenic in copper flash smelting slags

Mechanism of Arsenic Migration and Transformation During Pulverized Coal Combustion

Formation and In-Situ Dissociation of Particulate Arsenic in the Zinc-Containing Flue Gas from Nonferrous Metallurgy

Partitioning Behavior of Arsenic in an Ultra-Supercritical Coal-Fired Power Plant Equipped with APCDs for Ultra-Low Emission

Deep insights on arsenic speciation and partition in coal-fired particles from micro to nano size

Arsenic Exposure Levels in Relation to Different Working Departments in a Copper Mining and Smelting Plant

Mechanism Research on Arsenic Removal from Arsenopyrite Ore During A Sintering Process

Speciation transformation of arsenic during municipal solid waste incineration

Efficient and safe disposition of arsenic by incorporation in smelting slag through copper flash smelting process

Mineralogical and morphological factors affecting the separation of copper and arsenic in flash copper smelting slag flotation beneficiation process.