Abstract:Slag tailings are produced by “cooling-grinding-ball milling-flotation” and other processes of slag, while slag is produced by the flash smelting of the original ore. The utilization and environmental hazards of arsenic in slag tailings have become a focus of attention. This study on slag tailings reveals the presence of arsenic in copper smelting tailings from the mineralogy and leaching perspectives, and the noncarcinogenic and carcinogenic risks of arsenic to the human body were assessed by using the USEPA health risk model. The surface particles of the slag tailings were unevenly dispersed, and the mineral crystals were relatively complete. A small amount of secondary minerals had grown on the mineral surface. Most of the fine particles adhered to the surface of the main mineral to form inclusions. The mineral composition of the slag tailings was dominated by maghemite (Fe3O4) and fayalite (Fe2SiO4), and the arsenic-bearing minerals were unevenly distributed, where As (Ⅴ) fine particles were embedded in maghemite, amorphous phase and fayalite. There was a large amount of residual arsenic in the slag tailing particles, and the leaching content of arsenic in the toxicity leaching procedure was always lower than the limit of 5 mg/L. The health risk to the exposed population was evaluated by the USEPA health risk model. Since the exposed population in the industrial land is mainly adults, it is determined that the tailings will not cause harm to children's health. In this evaluation, the exposure duration (length of service of the workers) of 30 years, exposure frequency of 314 d/y and body weight of 60 kg (average weight of the workers) were taken as the parameters of three exposure pathways: hand-oral ingestion, respiratory system inhalation and skin contact. Therefore, longer activity time of the workers in the tailing workshop corresponds to a higher HI (hazard index). Although the arsenic in the slag tailings had a certain degree of bioavailability, it was not sufficient to adversely affect human health.

Mineralogical and morphological factors affecting the separation of copper and arsenic in flash copper smelting slag flotation beneficiation process.

Mineralogical characteristics of copper smelting slag affecting the synchronous flotation enrichment of copper and arsenic

Simultaneous recovery of arsenic and copper from copper smelting slag by flotation: Redistribution behavior and toxicity investigation

Determination of occurrence and leaching toxicity of arsenic in copper flash smelting slags

Efficient and safe disposition of arsenic by incorporation in smelting slag through copper flash smelting process

Speciation Characterization and Environmental Stability of Arsenic in Arsenic-Containing Copper Slag Tailing

Strategies for arsenic pollution control from copper pyrometallurgy based on the study of arsenic sources, emission pathways and speciation characterization in copper flash smelting systems

Performance and Mechanism of Arsenic-Metal Separation in Copper Smelting Flue Gas Regulated by Chalcopyrite

Study on the mechanism of copper and arsenic separation in copper smelting acidic solution by arsenic sulfide residue

Mechanism of arsenic distribution and migration during iron extraction by copper slag-steel slag combined reforming: A potential solution to refractory wastes

Characterization, Concentration, and Speciation of Metal Elements in Copper Slag: Implications for Secondary Metal Recovery

Quantitative characterization and magnetic separation of copper pyrometallurgical tailing for molybdenum and copper pre-concentration and cleaning of environmentally hazardous elements

Formation of Arsenic−copper-Containing Particles and Their Sulfation Decomposition Mechanism in Copper Smelting Flue Gas

An experimental comparison: Horizontal evaluation of valuable metal extraction and arsenic emission characteristics of tailings from different copper smelting slag recovery processes.

An effective separation process of arsenic, lead, and zinc from high arsenic-containing copper smelting ashes by alkali leaching followed by sulfide precipitation

Arsenic removal from acid extraction solutions of copper smelting flue dust

Study on selectively separating iron constituents in copper smelting slags

Recovery of value-added products from copper slag by pyrometallurgy: Transfer and structure of arsenic compounds

Study of the Micromorphology and Health Risks of Arsenic in Copper Smelting Slag Tailings for Safe Resource Utilization.

Simulation Study and Industrial Application of Enhanced Arsenic Removal by Regulating the Proportion of Concentrates in the SKS Copper Smelting Process

The Recovery of Copper from Smelting Slag by Flotation Process