Abstract:Liquified hydrogen, which is expected to be a next-generation, environmentally friendly energy source, can be used as a cryogenic refrigerant. A cryogenic precooler (a heat exchanger between air and liquified hydrogen) has been developed for the hypersonic engine in the aerospace field. It cools the incoming air compressed at the engine's air intake using liquified hydrogen (cryogenic fuel) as a refrigerant to save the core engine from heat load and improve efficiency. However, frost formation in a precooler is a severe issue. In the present study, we developed a valid numerical method for predicting frost formation on cryogenic temperature surfaces to avoid frosting problems. The feature of the present model is considering the frost growth due to fog deposition, which has not been considered in the previous models, in addition to desublimation and fog formation. We conducted verification analyses for the frosting under forced convection on a flat cold plate at −170 °C. On an ultra-low temperature plate (−170 °C), the characteristic phenomena, including frost layer separation, were reproduced, and the frost mass and height were in quantitative agreement with the experimental data. The numerical results clarified the water vapor consumption due to fog formation and the contribution of desublimation and fog deposition to frost growth. Desublimation was dominant at the front end. On the rear side, fog formation was initially significant, and its deposition was dominant. Desublimation was suppressed because fog formation consumed water vapor. After that, the dominant mechanism gradually changed from fog deposition to desublimation because fog formation was gradually suppressed with time. These results were consistent with the experimental observation. Moreover, we also confirmed the validity of the present model for frosting on a plate of −75 °C, in which the influence of fog formation and deposition differed from at −170 °C. The model developed in this research can simulate frost formation on various temperature surfaces, from general-low temperatures where only desublimation is dominant to ultra-low temperatures where fog formation and deposition have significant impacts.

A CFD Model of Frost Formation Based on Dynamic Meshes Technique Via Secondary Development of ANSYS Fluent

A new time- and space-dependent model for predicting frost formation

A modified CFD model for frosting on a horizontal plate

Modeling the Airside Dynamic Behavior of a Heat Exchanger under Frosting Conditions

Numerical Simulations of Frost Growth Using Mixture Model on Surfaces with Different Wettability

A Numerical Study of Heterogeneous Nucleation of Ice Crystals and Frost Layer Growth on Horizontal Cold Surfaces

Two-dimensional simulation of frost formation on the NACA0012 airfoil under strong convection by using the p-VOF method

Numerical Prediction of Spatio-Temporal Frosting Patterns of Curved Surface Considering Varying Working Parameters

Investigation of the Morphology and Heat Transfer Characteristics of the Frost Layer During the Early-Stage Formation with a Cellular Automata Model

Numerical Simulation of Frost Layer Growth on a Horizontal Plate

A new model for predicting performance of fin-and-tube heat exchanger under frost condition

Experimental and Numerical Investigations of Frost Formation on Wavy Plates

Frost model and numerical simulation of air-heating fin-tube vaporizer

Numerical Prediction of Frosting Growth Characteristics of Microchannel Louvered Fin Heat Exchanger

Simulation of Frost Growth and Densification on Horizontal Plates with Supersaturated Interface Condition

A Semi-empirical Model of Frost Formation on a Cryogenic Surface Cooled from Ambient Temperature under Forced Convection Condition

Development of a numerical model for frost formation on ultra-low temperature surfaces considering both desublimation and fog deposition

Simulation and Experimental Study on Finned-Tube Evaporators in the Frosting Process

Frost-Air Interface Characterization Under Natural Convection

Numerical Simulation of Frosting on Wavy Fin-and-tube Heat Exchanger Surfaces

Prediction of heat and mass transfer inside 3D frost microstructure