Braking Performance of Fe-Based and Cu-Based Powder Metallurgy Pads Paired with C/C-SiC Disk on Full-Scale Dynamometer
Weiguang Zhong,Xinhao Zhang,Xiaolu Zhang,Qingzhi Yan
DOI: https://doi.org/10.1080/10402004.2024.2340713
IF: 2.056
2024-05-04
Tribology Transactions
Abstract:In this study, the friction performance of copper-based (Cu-PM) and iron-based (Fe-PM) powder metallurgy pads was systematically compared and analyzed by performing a braking test paired with a C/C-SiC disk on a full-scale flywheel brake dynamometer, including coefficient of friction (COF), wear rate (Wr), and worn surface under dry and wet tests. The test procedure simulated the braking conditions on high-speed trains with initial brake speeds (IBS) from 50 km/h to 200 km/h, as well as under various brake clamping forces (F B ). During dry tests, both pads exhibited high levels of COF. The mean value of average COF (μ m ) for the Cu-PM pad was 0.371, which was slightly higher than that of 0.358 from the Fe-PM pad. The stability of μ m over the IBS ranged from 68% to 82% for Cu-PM pads under different F B , while it was from 82% to 85% for Fe-PM pads. However, during the wet tests, the mean value of μ m dropped to 0.207 for Cu-PM pads, and with the minimum μ m of 0.062; whereas, they were 0.344 and 0.188 for Fe-PM pads, respectively, showing a significant difference in the friction performance between the two pads. Additionally, the W r of the Cu-PM pad was 0.110 cm 3 /MJ during dry tests, which was 17.3% lower than that of 0.133 cm 3 /MJ observed for the Fe-PM pad. After the brake test with the Cu-PM pad, the friction film primarily covered the Si/SiC-rich region of the disk, effectively inhibiting the plowing of SiC hard asperities onto the pad surface. However, the friction film predominantly covered the fiber-rich region of the disk after the test with the Fe-PM pad, and the exposure of hard Si/SiC-rich asperities would continuously plow the pad during braking and resulted in furrows on the surface of the Fe-PM pad. In terms of wear mechanisms, adhesion wear was the primary mechanism on the contact surfaces of the Cu-PM pad and the C/C-SiC disk, while abrasion dominated the interaction between the Fe-PM pad and the C/C-SiC disk. This study provides valuable insights for the application of C/C-SiC brake disks on trains.
engineering, mechanical