Numerical and Experimental Study on Co-Firing of Low Volatile Coal in a 330 MW Tangentially Fired Boiler

Xing Liu,Jiaye Zhang,Houzhang Tan,Qingfeng Mo,Xuebin Wang,Yibin Wang

DOI: https://doi.org/10.1016/j.joei.2021.03.015

IF: 6.47

2021-01-01

Journal of the Energy Institute

Abstract:Burnout related problem occurs in the utility boiler burning low volatile coals. The in-furnace co-firing of low volatile coal (LV) experiments and simulation were carried out in a tangentially fired PC furnace to investigate the effect of co-firing ratio, injection position and particle size on NOx emission and carbon in fly ash (C-fh). The results of full-scale experiment show that C-fh increases from 2.16% to 4.21% as the LV co firing ratio rises from 33% to 50%, while the NOx emission increases from 356.0 mg/Nm(3) to 385.2 mg/Nm(3) (@6% O-2). The model is validated against the experimental data. The numerical simulation results show that NOx increases from 308 mg/Nm(3) to 567 mg/Nm(3) when the co-firing ratio of LV increases from 0% to 100%, while C-fh increases from 1.20% to 7.15%. It is found that the contribution of top two layers (E and F) to the total C-fh is significantly higher than that of the other layers. Under the working conditions of burning bituminous coal in the bottom layer and lean coal (particle size 70 mu m) in the upper five layers, C-fh is 5.4%. When the particle size of lean coal in the five layers is reduced to 40 mu m, C-fh rapidly decreases to 2.0%. And the C-fh can be reduced to 2.5% when only the top two layers feeding lean coal with smaller particle size (40 mu m). Only 40% marginal cost of coal grinding is needed to reach the marginal benefit corresponding to 83% C-fh improvement while all layers of LV coal are ground into the small size. (C) 2021 Energy Institute. Published by Elsevier Ltd. All rights reserved.