Abstract:Burnout related problem occurs in the utility boiler burning low volatile coals. The in-furnace co-firing of low volatile coal (LV) experiments and simulation were carried out in a tangentially fired PC furnace to investigate the effect of co-firing ratio, injection position and particle size on NOx emission and carbon in fly ash (C-fh). The results of full-scale experiment show that C-fh increases from 2.16% to 4.21% as the LV co firing ratio rises from 33% to 50%, while the NOx emission increases from 356.0 mg/Nm(3) to 385.2 mg/Nm(3) (@6% O-2). The model is validated against the experimental data. The numerical simulation results show that NOx increases from 308 mg/Nm(3) to 567 mg/Nm(3) when the co-firing ratio of LV increases from 0% to 100%, while C-fh increases from 1.20% to 7.15%. It is found that the contribution of top two layers (E and F) to the total C-fh is significantly higher than that of the other layers. Under the working conditions of burning bituminous coal in the bottom layer and lean coal (particle size 70 mu m) in the upper five layers, C-fh is 5.4%. When the particle size of lean coal in the five layers is reduced to 40 mu m, C-fh rapidly decreases to 2.0%. And the C-fh can be reduced to 2.5% when only the top two layers feeding lean coal with smaller particle size (40 mu m). Only 40% marginal cost of coal grinding is needed to reach the marginal benefit corresponding to 83% C-fh improvement while all layers of LV coal are ground into the small size. (C) 2021 Energy Institute. Published by Elsevier Ltd. All rights reserved.

FURTHER STUDIES ON THE COAL COMBUSTION BEHAVIOR IN THE TANGENTIALLY FIRED BOILER FURNACE

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Numerical investigation on oxy-combustion characteristics of a 200MW e tangentially fired boiler

Numerical Simulation of Flow and Combustion Process in the Tangentially Fired Furnace of a 200 MW Pulverized Coal Boiler

Investigation Of Coal Reactivity Effects On A 1000-Mw Tangential Coal-Firing Boiler

Numerical Investigation on the Flow, Combustion, and NOX Emission Characteristics in a 660 MWe Tangential Firing Ultra-Supercritical Boiler

Numerical Simulation On The Combustion Process In The Furnace Of A Lignite-Fired Usc Boiler

Experimental study and numerical simulation on the gas-solid two-phase flow field in the furnace of a 300MW tangentially fired utility boiler

Study on coal combustion characteristics in a W-shaped boiler furnace

Numerical and Experimental Study on Co-Firing of Low Volatile Coal in a 330 MW Tangentially Fired Boiler

Computational modeling of pulverized coal combustion processes in tangentially fired furnaces

Numerical Analyses of Effect of Air Distribution on Combustion Characteristics of Tangentially Pulverized Coal-Fired Boiler

Experimental and Numerical Investigations on Heat Transfer Characteristics of a 35MW Oxy-Fuel Combustion Boiler

Numerical Simulation Of The Combustion Processes In A W-Shaped Boiler Furnace Under Different Operating Conditions

Numerical Investigation of Combustion Optimization in a Tangential Firing Boiler Considering Steam Tube Overheating

Simulation and Experimental Research on Gas Temperature Deviation on Converting to Bituminous Coals in Tangentially Lean Coal Boiler

Experimental and Modeling Study on Char Combustion

Numerical Simulation on 200MWe Tangential-fired Boiler for Oxy-firing Characteristics

Numerical Study of Operation Parameters on Pulverized Coal Ignition and Unburned Carbon in Fly Ash for a Boiler

Study on experiments and numerical simulation of coal combustion characteristics under different thermal environments

The investigation and measurement on the pulverized coal combustion in tangentially-fired boiler