Abstract:The most common defect found in the high pressure die casting(HPDC) process is gas porosity which significantly affects the mechanical properties of the final components.As it is known,the air entrapment of the liquid metal flow during the mold filling stage has a close relationship with the gas porosity distribution in die castings.The generation of the entrapped air is mainly due to the interaction between air and liquid metal in the die cavity.In the past few decades,extensive efforts have been made to develop numerical models for the simulation of mold filling.However,these efforts mainly focused on the single phase flow models which can only predict the liquid metal flow and assume that the effect of air in the die cavity is negligible.As a result, these models could not provide the quantity and location of entrapped air in die castings.Recently, several research results on tracking the entrapped air in the molten metal flow have been reported but some techniques still need to be improved further and much more researches are required.In this study,a liquid-gas coupled model is presented to simulate the air entrapment phenomenon during the HPDC mold filling process.The pressure of the entrapped air bubbles is solved at each time step. The calculations of the liquid and gas phases are combined together through the pressure transfer.In order to verify the validity and stability of this model,a specially designed water analog experiment was carried out and compared with the numerical simulation results of the liquid-gas coupled model and the single phase flow model,respectively.The comparison shows that the liquid-gas coupled model has better prediction accuracy than the single phase flow model in tracking the entrapped air bubbles.

Filling a Hole by Capillary Flow of Liquid Metal–equilibria and Instabilities

Effects of Gravity on the Capillary Flow of a Molten Metal

SURFACE TENSION DRIVEN MOLTEN METAL FLOW OVER FLAT AND/OR GROOVED REACTIVE SURFACES DURING BRAZING AND SOLDERING

Filling Kinetics of Zr-based Amorphous Supercooled Liquid in Micro Filling Process with Longer Unsteady Flow

Capillary Driven Molten Metal Flow over Topographically Complex Substrates.

Contact angle ageing and anomalous capillary flow of a molten metal

Molten Filling in Vertical Centrifugal Casting and Its Numerical Simulation

Numerical and experimental study of flowing and spreading of silver-based filler metal droplet on different substrates during laser brazing process

Scaling of Molten Metal Brazing Phenomena: Prolegomena for Model Formulation

Molten aluminum equilibrium membrane formed during controlled atmosphere brazing

Anomalous Capillary Flow of Molten Al Si Alloy and Macrosegregation

Tubeless Siphon Flow of Room Temperature Liquid Metal

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process

Non-Equilibrium Diffusion-Controlled Melting and Re-Solidification of Thin Metal Layers on a Reactive Substrate

Precise filling time calculation of thin-walled investment casting in hot mold

Prediction of the Fillet Mass and Topology of Aluminum Brazed Joints

Numerical simulation and optimization of liquid metal flow in the shot sleeve of cold chamber die casting process

Mechanics and Forming Theory of Liquid Metal Forging

Hydrogen microporosity evolution and dendrite growth during long solidification of Al-Cu-Li alloys: Modeling and experiment

Particle-based Porous Materials for the Rapid and Spontaneous Diffusion of Liquid Metals.

Underfill flow as viscous flow between parallel plates driven by capillary action