Abstract:Material microstructures often contain non-uniformly distributed features of complex geometry. Attributes of three-dimensional microstructural geometry have dominant influence on the mechanical behavior of materials. Therefore, it is of interest to incorporate quantitative description of actual three-dimensional microstructures in micromechanical analysis of materials. In this contribution, a methodology has been developed to perform finite element (FE)-based simulations on complex three-dimensional microstructures, through its application to cast microstructure of A356 Al-alloy containing non-uniformly distributed pores of complex geometry. As expected, the simulations reveal that the distributions of local stresses and strains depend on size, orientation, and spatial arrangement of the pores in a complex manner. FE-simulations on the three-dimensional pore structure have been used to simulate the growth of the voids by the McClintock rule. These simulations clearly demonstrate that unit cell model can be used in the study the void growth behavior of materials at the stress levels close to global yield stress, and it overestimates the void growth at the stress levels significantly higher global yield stress. The FE-simulations reveal a general trend that larger voids have a higher percentage increase in their volume. Therefore, at a given applied stress level, absolute rate of volume change of a pore increases with its initial pore volume in a non-linear manner. These observations are supported by experimental measurements of pore growth. It is shown that micromechanical response does not vary significantly if the pores are replaced by equivalent ellipsoids, and such a model can be used to simulate the growth of non-uniformly distributed voids of complex geometry at all stress levels.

Progress in Finite Element Simulation of Micromechanics of Multi-Phase Materials

Micromechanical Simulation on Strength and Ductility of Two Kinds of Al-based Nanostructural Materials

Estimating mechanical properties of bi-continuous two-phase composites for optimised multi-functionality

Development of Phase-Field Modeling in Materials Science in China: A Review

Review of Computational Methods on Phase-Field Simulation

Phase-field method of materials microstructures and properties

A Multi-Phase Model for Transformation Plasticity Using Thermodynamics-Based Metallurgical Algorithm

Phase-field Model Simulations of Alloy Directional Solidification and Seaweed-Like Microstructure Evolution Based on Adaptive Finite Element Method

3D Finite Element Simulation of Complex Static and Dynamic Fracture in Quasi-Brittle Materials

Micromechanics of complex three-dimensional microstructures

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Phase Field Simulation of Multiple Phase Transformation of Fe-C Alloy During Solidification Process

Finite Element Modeling of Microstructures in Composite Materials: A Special Issue in Materials

Simulation of Microstructure Evolution in Mg Alloys by Phase-Field Methods: A Review

Three-Dimensional Parametric Finite-Volume Homogenization of Periodic Materials with Multi-Scale Structural Applications

A Virtual Scale Approach to Multi-Scale Calculations and Its Application in Fiber-Reinforced Composites

Computer simulation of super-magnetoelastic behavior near critical region of magnetic materials based on phase-field method

Recent research progress on the phase-field model of microstructural evolution during metal solidification

Computer Simulation Analysis for Material Mechanics

Applications of unified phase-field methods to designing microstructures and mechanical properties of alloys

An Efficient Method for Multiscale Modelling of the Mechanical Properties of Additively Manufactured Parts with Site-specific Microstructures