Abstract:The current high volume of plastic waste, but low recycling rate, has led to environmental pollution and wasted energy. Greenhouse gas CO2 can facilitate thermal cracking to dehydrogenate waste plastics, and has potential value for producing olefins. In this work, the pyrolysis properties of low-density polyethylene (LDPE) were studied by thermogravimetric analysis and Py-GC/MS. The effect of the pyrolysis atmosphere, using N2 or CO2, with various MCM-41 catalyst ratios on pyrolysis product distribution, were investigated. The experimental results show that the olefin selectivity under a N2 atmosphere was from 30.32 % to 44.66 % which increased as the MCM-41 catalyst was increased. Under a CO2 atmosphere, the olefin selectivity reached a maximum of 60.39 %. The Boudouard reaction was also enhanced by the introduction of CO2. The carbon content of the subdivided olefins showed that in CO2, the promotion of C5-C12 olefins was relatively weak when non-catalyzed or at low catalytic ratios, but increased significantly at higher MCM-41 catalyst ratios. With a ratio of LDPE: MCM-41 = 5:4, the CO2 atmosphere showed the greatest promotion of C5-C12 olefins over N2, with an increase of 14.66 % compared to N2, representing a 48.54 % yield of the liquid product. Producing C5-C12 olefins under these conditions maximized energy efficiency. These results show that catalytic pyrolysis of LDPE under a CO2 atmosphere has great potential to produce C5-C12 olefins, which can be used to produce high-value chemicals such as naphtha and gasoline. This opens new opportunities for the chemical recycling of plastic waste.

Method for producing propylene ethane by carbon-containing olefin catalytic cracking

Method for separating carbon-containing olefin cracked product

Direct Conversion of Methane to Propylene

Catalytic thermal cracking of mixtures of bamboo waste and polypropylene

Low-Temperature-Initiated Cracking of Hydrocarbons to Produce Olefins: Simulation and Comparison of Different Initiators

THERMODYNAMICS ANALYSIS AND REACTION PERFORMANCE OF THE PRODUCTION OF PROPYLENE AND ETHYLENE FROM C4OLEFINS CRACKING

Method for increasing yield of propylene

Study on Production of Propylene from C4 Olefins by Catalytic Cracking

Method for preparing isopropanol and ethanol by taking propylene and acetic acid as raw materials

Turbulent fluidized bed reactor, device and method for preparing propylene and C4 hydrocarbons from oxygen containing compound

1-Hexene catalytic cracking to propylene using shape selective molecular sieve sapo-34 zeolite

Produce petrochemicals directly from crude oil catalytic cracking, a techno-economic analysis and life cycle society-environment assessment

Study on Thermodynamics of Butene Catalytic Cracking to Propene and Ethene

Method to produce low-carbon olefin from methanol or DME

dispositivo e método para fabricar propeno e hidrocarbonetos c4

Method for increasing selectivity of low-carbon olefins in methanol or dimethyl ether converting process

Development of Propylene Production Enhancement Technology

Production of C5-C12 olefins by catalytic pyrolysis of low-density polyethylene with MCM-41 in CO2/N2

THERMODYNAMIC ANALYSIS OF PROPYLENE-ENHANCING FCC PROCESS

Kinetics of Coupling Cracking of Butene and Pentene on Modified HZSM-5 Catalyst

Highly effective conversion of CO2 into light olefins abundant in ethene