Abstract:The grain size prior to cold rolling plays an important role in the microstructural, textural evolution and magnetic properties of non-oriented silicon steel sheets. In this work, we proposed a new way to obtain large grain size before cold rolling and applied it to a 1.0 wt% Si-0.2 wt% Al non-oriented silicon steel, i.e., appropriate low-finishing-temperature hot rolling combined with batch annealing. The grain growth process during batch annealing was investigated using a quasi in-situ electron backscattered diffraction (EBSD) technique. It was demonstrated that significant grain growth took place through a strain-induced boundary migration mechanism. Then a large number of in-grain shear bands were formed in the cold rolled microstructure and could provide nucleation sites for Goss ({110} 〈001〉 ) and λ-fiber (〈001〉//ND) recrystallized grains, thus resulting in a coarse-grained and homogeneous recrystallization microstructure with weakened γ-fiber (〈111〉//ND) texture, strengthened Goss and λ-fiber texture. Consequently, superior magnetic properties (B50 = 1.763 T, P1.5/50 = 4.30 W/kg) were obtained. For comparison, the conventional processing route without batch annealing was also investigated. A small-grained and inhomogeneous recrystallization microstructure with pronounced γ-fiber texture was produced in the finally annealed sheet, which could significantly deteriorate both the magnetic induction and iron loss. This work provided a new way to enlarge the grains in hot rolled sheets by low temperature batch annealing instead of the conventional high temperature normalization. Thus a new processing route to fabricate low silicon non-oriented electrical steels with high permeability and low iron loss was established.

Method for producing high magnetic induction orientation silicon steel with excellent magnetic performance and good bottom layer

Manufacturing high nitrogen austenitic stainless steels by pressurized induction furnace

Fabrication of high-performance low silicon non-oriented electrical steels by a new method: Low-finishing-temperature hot rolling combined with batch annealing

Thick-Gauge Ultra-High-Strength High-Silicon Non-Oriented Silicon Steel with Balanced Mechanical and Magnetic Properties Controlled by Partial Recrystallization Annealing

Effect of normalizing on magnetic properties of high-manganese 50W470 non-oriented silicon steel

Influence of Annealing Process on Microstructures,Mechanical and Magnetic Properties of Nb-Containing High-Strength Non-Oriented Silicon Steel

Effect of normalizing cooling process on microstructure and precipitates in low-temperature silicon steel

Study on Microstructure and Precipitates at Different Normalizing in Fe-3.15%Si Low Temperature Oriented Silicon Steel

Investigation of the main factors affecting the magnetic properties of silicon steel sheets by comparing three kinds of silicon steel

Application and Development of High Magnetic Flux Density Low Iron Loss Non-oriented Silicon Steel

Effect of recrystallization annealing temperature on microstructure, texture and magnetic properties of non-oriented silicon steel produced by strip casting

Study on microstructure and texture of a new-type low Si high Mn non-oriented silicon steel 50W250

A study of Laves phase in high Nb non-oriented silicon steel for electric automobiles

6.5 wt% Si high silicon steel sheets prepared by composite electrodeposition in magnetic field

Evolutions of microstructure and magnetic properties of heatproof domain-refined silicon steel during annealing and its application

Magnetic Performance Improvement Caused by Tensile Stress in Equivalent Iron Core Fabricated by High-Strength Non-Oriented Electrical Steel

The Significance of Microstructure and Texture on Magnetic Properties of Non‐Oriented Silicon Steel: Strip Casting versus Conventional Process

Improved magnetic properties of grain-oriented silicon steel by in-situ formation of potassium zirconium phosphate in insulating coating

Microstructure Characteristics and Strengthening Behavior of Cu-Bearing Non-Oriented Silicon Steel: Conventional Process versus Strip Casting

Microstructure and texture evolution of thin-gauge non-oriented silicon steel with high permeability produced by twin-roll strip casting