Abstract:A novel assembly was developed for hot-shock consolidations of powders. The under-water shock wave and the high-temperature preheating, which are considered as two effective ways to eliminate cracks, were combined in the system. In this work, a SHS (self-propagating high-temperature synthesis) reaction mixture was used as chemical furnace to preheat the precursor powder, and the water column as well as the explosive attached to it was detached from the furnace by a solenoid valve fixed on the slide guide. When the precursor powders were preheated to the designed temperature, the solenoid valve was switched on, and then the water column and the explosive slid down along the slide guide by gravity. At the moment the water container contacted with the lower part, the explosive was initiated, and the generated shock wave propagated through the water column to compact the powders. So the explosive and water column can be kept cool during the preheating process. The intensity of shock wave loading can be adjusted by changing the heights of water column. And the preheating temperature is controlled in the range of 700∼1300 °C by changing the mass of the SHS mixture. In this work, pure tungsten powders and tungsten-copper mixture were separately compacted using this new assembly. The pure tungsten powder with a grain size of 2 μm were compacted to high density (96 %T.D.) at 1300 °C, and the 90W-10Cu (wt pct) mixtures were compacted to 95.3 %T.D. at 970 °C. The results showed that both samples were free of cracks. The consolidated specimens were then characterized using SEM analysis and micro-hardness testing.

Shock-induced Consolidation of Tungsten Nanoparticles-a Molecular Dynamics Approach

Molecular Dynamics Simulation of Shock Consolidation of Nano Tungsten Powder

Shock Consolidation of Ni/Al Nanoparticles: A Molecular Dynamics Simulation

Shock-Induced Consolidation and Spallation of Cu Nanopowders

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Experiment Study on the Hot-Shock Consolidation of Tungsten Powder

Melting Curves And Entropy Of Fusion Of Body-Centered Cubic Tungsten Under Pressure

Fabrication and Characterization of Pure Tungsten Using the Hot-Shock Consolidation

Tungsten-Copper Composite Fabricated by Hot-Shock Consolidation

Molecular Dynamic Simulation on Shock Plasticity Behaviour of Tungsten Alloy

Shock consolidation and the corresponding plasticity in nanopowdered Mg

Abstract Submitted for the SHOCK11 Meeting of the American Physical Society Fabrication of W-Cu Composites by Hot-Shock Consolidation

Shock-induced plastic deformation of nanopowder Ti during consolidation and spallation

A Molecular Dynamics Study of Coalescence of Tungsten Nanoparticles

Orientation-dependent Responses of Tungsten Single Crystal under Shock Compression Via Molecular Dynamics Simulations

Microstructural Evolution, Shocking Sintering Mechanism and Dynamic Mechanical Behaviours of Silica Nanoparticles Acting As Catalyst Carrier in Energetic Nanomaterials During Shock-Wave Impact

Size-dependent melting and coalescence of tungsten nanoclusters via molecular dynamics simulation.

A Novel Assembly Used for Hot-Shock Consolidation

Structural Evolution of Nanoparticles under Picosecond Stress Wave Consolidation

Dynamic Characterization of Shock Wave Responses of Bicontinuous Nanoporous Amorphous Alloys: Microstructure Effects

Characterization of fine-grained W–10wt.% Cu composite fabricated by hot-shock consolidation