Abstract:Heterojunction with intrinsic thin-layer (HIT) solar cells attract attention due to their high open circuit voltage and stable performance. However, short circuit current density is difficult to improve due to light losses of transparent conductive oxide and hydrogenated amorphous silicon passivation (a-Si:H) layer and low absorption coefficient of crystalline silicon (c-Si). Silicon germanium alloy (Si/Si1-xGex) quantum wells and quantum dots are capable of improving low light utilization by strong optical absorption in the infrared region. In this article, opto-MoS2of the HIT solar cells integrated with Si/Si1-xGex quantum wells (HIT-QW) as a surface absorber are investigated by numerical simulation with Technology Computer Aided Design (TCAD). The influences of germanium content on the MoS2of HIT solar cells with long carrier lifetimes of Si1-xGex layers (p*) and defect-free a-Si:H/c-Si interface are investigated at first. The simulation results indicate that optical utilization in the infrared region is enhanced with the increase of germanium fraction, while open circuit voltage degrades due to the decreasing of the energy band gap of Si1-xGex, radiative recombination and auger recombination mechanism in the Si/Si1-xGex quantum wells. And the conversion efficiency reaches a maximum value at a germanium fraction of 0.25 then drops distinctly. When the germanium fraction increases from 0 to 0.25, the short circuit current density increases from 34.3 mA/cm2 to 34.8 mA/cm2, while the open circuit voltage declines from 749 mV to 733 mV. Hence, the conversion efficiency increases from 21.5% to 21.7% due to the fact that the enhancement of short circuit current density compensates for the reduction of open circuit voltage. When the germanium content increases to more than 50%, a serious open circuit voltage loss of more than 130 mV associated with the energy band gap loss of Si1-xGex arises in the HIT-QW solar cells, which indicates that the dominating carrier transport mechanism changes from shockley diffusion to recombination in the Si/Si1-xGex quantum wells. Subsequently, the influences of interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells are discussed. Both interface holes at a-Si:H/c-Si interface and bulk holes in Si1-xGex quantum wells can be recombined through the interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells, respectively, which restricts the position of hole fermi level in the open circuit condition. When the germanium fraction increases, the influence of interface defects at a-Si:H/c-Si interface becomes weak on the degradation of open circuit voltage compared with the significant influence of the bulk trap centers. Moreover, p* of longer than 510-5 s is necessary for the retention of electrical performance of HIT-QW solar cells by the simulation. Based on this research, high-efficiency HIT solar cells can be achieved by incorporating high-quality Si/Si0.75Ge0.25 quantum wells, which also requires the impactful passivation of a-Si:H/c-Si interface.

Numerical Simulations of Multilevel Impurity Photovoltaic Effect in the Sulfur Doped Crystalline Silicon

Silicon Quantum Dot Based Solar Cells: Addressing the Issues of Doping, Voltage and Current Transport

Silicon Rich Carbide As A Conductive Substrate For Si Qd Solar Cells

Study on the Fermi level of microstructured Silicon with impurities introduced by chalcogenides and their affect on solar cell efficiency

Impurities in 4H Silicon Carbide: Site Preference, Lattice Distortion, Solubility, and Charge Transition Levels

Theoretical insight into the enhancement of longer-wavelength light absorption in silicon solar cell with multilevel impurities

Efficiency improvement for post-sulfurized CIGS solar cells enabled by in situ Na doping

Improved Nanocrystal Formation, Quantum Confinement and Carrier Transport Properties of Doped Si Quantum Dot Superlattices for Third Generation Photovoltaics

n-Type Doping of Sb2S3 Light-Harvesting Films Enabling High-Efficiency Planar Heterojunction Solar Cells.

Sulfur-Infused Hole Transport Materials to Overcome Performance-Limiting Transport in Colloidal Quantum Dot Solar Cells

Numerical Simulation of Silicon Heterojunction Solar Cells with Si/Si1-xGex Quantum Wells

Intrinsic Defect Limit to the Electrical Conductivity and a Two-Step p-Type Doping Strategy for Overcoming the Efficiency Bottleneck of Sb2S3-Based Solar Cells

A Codoping Strategy for Efficient Planar Heterojunction Sb2S3 Solar Cells

Improved Device Performance of Si-based Heterojunction Solar Cells by Using Phosphorus Doped Si Nanocrystals Embedded in SiC Host Matrix

Influence of gettering and passivation on uniformity of the electrical parameters in monolithic multicrystalline silicon solar cell

Towards high-efficiency planar heterojunction antimony sulfide solar cells

Numerical Investigation of CuSbS2Thin Film Solar Cell using SCAPS-1D: Enhancement of Efficiency on Experimental Films by Defect Studies

Study on the Effect of Melt Flow Behavior on the Uniformity of Phosphorus Doping During the Growth of Large-Size N-Type Monocrystalline Silicon by Czochralski Method

Optimization of preparation conditions and design of device configurations for Cu3AsS4 solar cells: a combined study of first-principles calculations and SCAPS-1D device simulations

Optimized Phosphorus Diffusion Process and Performance Improvement of C-Si Solar Cell by Eliminating SiP Precipitates in the Emitter

Effect of diffusion doping-induced defects on shunt resistance affecting Si-nanowire solar cell performance