Abstract:Perforated plates/liners have been widely applied in aeroengines and gas turbines to dissipate unwanted noise. In this work, numerical simulations and experimental study of acoustic damping performance of single-layer perforated plates are conducted. For this, a frequency-domain numerical model is developed via solving 3-dimensional Helmholtz equations. The model validation is performed first by evaluating and comparing the calculated acoustic damping performances of three perforated plates with the experimental results available in literature. These plates are perforated with a number of circle-shaped orifices, which have different porosities σ. Each plate backed by a resonant cavity is placed at the end of a rectangular-shaped pipe with a loudspeaker implemented on the other end. To simulate real engines, a mean flow (also known as bias flow) is applied to pass through the perforated orifices. The effects of 1) the mean flow Mach number Ma, 2) the resonance parameter Q, 3) the porosity σ and 4) the plate thickness T are studied one at a time. Acoustic damping performance of these plates is characterized by using sound absorption coefficient α and specific acoustic impedance z. It is found that sound absorption coefficient α is increased first and then decreased with increased Ma. The real part of z characterizing acoustic resistance/damping is linearly increased, as Ma is increased. However, the imaginary part of z characterizing acoustic reactance remains almost unchanged. It is also found that the presence of the bias flow greatly increases the maximum sound absorption coefficient αmax by approximately 33% in comparison with that of without mean flow. The plate thickness T is shown to shift the frequency corresponding to the maximum sound absorption coefficient. Comparing the present simulation results with the experimental and analytical ones available in the literature reveals that good agreement is obtained at lower frequency range. However, as frequency is increased, the model predicts that the bias flow leads to the local αmax reduced by 15%. The plate with a larger thickness is associated with another local αmax, which is not observed for a lower thickness plate. Finally, experimental measurements of the acoustic damping of 2 single-layer in-duct perforated plates are performed. The frequency-domain model is then applied to simulate the experiment. Good agreement between our experimental and numerical results is obtained.

Sound radiation from plates with elastic boundary conditions embedded in an infinite perforated rigid baffle

Computational Analysis of the Influence of the Perforated Plate on Sandwich Transducer in Sound Radiation Performance

The effect of ribs on the sound radiation directivity of rectangular plates

Sound Radiation from a Water Filled Pipe with an Attached Plate

Sound Transmission Through a Finite-Sized Double Panel Cavity with a Micro-Perforated Panel Insertion

Diffuse Sound Absorptive Properties of Parallel-Arranged Perforated Plates with Extended Tubes and Porous Materials

Study on Sound Absorption Properties of Micro Perforated Plates with Acoustic Black Hole Back Cavities

Low-frequency Sound Absorptive Properties of Dual Perforated Plates under Bias Flow

Theoretical and experimental investigation on the low-frequency vibro-acoustic characteristics of a finite locally resonant plate

RADIATION DAMPING IN PLATES, INDUCED BY POROUS MEDIA

Broaden the sound absorption band by using micro-perforated plate back cavities with different cross-sectional areas

Study on sound pressure level and acoustic damping ratio of one dimensional sound field partitioned by perforated plate with geometric similarity

Study on the radiation directivity of a ring-excited thin circular plate with a fixed boundary

Study on Active Control of Sound Radiation From a Baffle in Sonar Equipment

Experimental and Frequency-Domain Study of Acoustic Damping of Single-Layer Perforated Plates

A semi-analytical method using auxiliary sine series for vibration and sound radiation of a rectangular plate with elastic edges

Vibration and Sound Radiation Analysis of Rectangular Plates Resting on Winkler Foundation in Thermal Environment with Closed Form Solutions

Sound Radiation Analysis of Functionally Graded Porous Plates with Arbitrary Boundary Conditions and Resting on Elastic Foundation

Analyzing Acoustic Radiation Modes of Baffled Plates with A Fast Multipole Boundary Element Method

Absorption of Oblique Incidence Sound by a Finite Micro-Perforated Panel Absorber

Sound radiation of parallelly stiffened plates under convected harmonic pressure excitation