Abstract:3D-printed carbon fiber composites hold significant potential in aerospace applications because of their lightweight, high strength and complex structure fabrication capabilities. However, additive manufacturing characteristics such as high porosity, anisotropy and continuous fiber content significantly affect the mechanical properties of printed parts. The aim of this study is to investigate the influence of hybrid printing of short and continuous carbon fibers on the mechanical properties and failure mechanisms of composites and to develop a model to predict elastic properties considering porosity. First, mechanical testing and characterization of short and continuous fiber reinforced polyamide (nylon) print filaments are performed. The results indicate that the elastic modulus and ultimate strength of continuous carbon fiber filaments reach 60 GPa and 1500 MPa, respectively, while the strength and elastic modulus of short carbon fiber filaments reach 60 MPa and 1 GPa, respectively. Then tensile specimens with different continuous fiber orientations and different continuous fiber placement sequences are printed and tested using a multi-material 3D printing technique. The specimens are characterized before and after testing using scanning electron microscopy and microscopy to assess the porosity and failure mechanisms of specimens with different configurations. The results show that the mechanical properties of the printed parts are much lower than those of the print filaments, which proves the serious negative impact of the material extrusion process on the mechanical properties of the printed structural parts. Finally, an analytical method for predicting the elastic behavior of printed composites is developed by introducing the porosity factor in the volume-averaged stiffness model. For continuous and short fiber filled composites with different fiber contents and printing orientations, the predicted results are in agreement with the experiments, and the prediction error is greatly reduced from 30% to less than 5%.

Prediction of Deformation and Failure Behavior of Continuous Fiber Reinforced Composite Fabricated by Additive Manufacturing

Experimental and Theoretical Studies on 3D Printed Short and Continuous Carbon Fiber Hybrid Reinforced Composites

Failure mode analysis and prediction model of additively manufactured continuous carbon fiber‐reinforced polylactic acid

An Approach for Damage Initiation and Propagation in Metal and Carbon Fiber Hybrid Composites Manufactured by Robotic Fiber Placement

Process evaluation, tensile properties, mathematical models, and fracture behavior of 3D printed continuous fiber reinforced thermoplastic composites

Dynamic Enhancement Induced by Interface for Additively Manufactured Continuous Carbon Fiber Reinforced Composites

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Large-scale deformation and damage detection of 3D printed continuous carbon fiber reinforced polymer-matrix composite structures

Comparison of Models to Predict Mechanical Properties of FR-AM Composites and a Fractographical Study

An investigation into mechanical properties of a 3D printed two-matrix continuous fiber composites with multi-cavity structure

A New Three-Dimensional Progressive Damage Model for Fiber-Reinforced Polymer Laminates and Its Applications to Large Open-Hole Panels

Experimental and Numerical Simulation on Formability and Failure Behavior of Thermoplastic Carbon Fiber/AL Composite Laminates

Progressive failure prediction of three-dimensional woven composites using a generic multi-scale analytical model

Autonomous intelligent additive manufacturing of continuous fiber-reinforced composites: data-enhanced knowledgebase and multi-sensor fusion

A Constitutive Model for 3D Printed Continuous Fiber Reinforced Composite Structures with Variable Fiber Content

Investigation on the mechanical properties of 3D printed hybrid continuous fiber-filled composite considering influence of interfaces

Extended Phase Field Modeling of Interface Debonding and Bulk Cracking in Realistic 3D Printed Fiber Reinforced Composites

Mechanical analysis and progressive failure prediction for fibre metal laminates using a 3D constitutive model

Path-Dependent Progressive Failure Analysis for 3D-Printed Continuous Carbon Fibre Reinforced Composites

Progressive Failure Prediction of FRP Tubes by Modified Damage Model

Process-dependent Multiscale Modeling for 3D Printing of Continuous Fiber-reinforced Composites