Abstract:3D-printed carbon fiber composites hold significant potential in aerospace applications because of their lightweight, high strength and complex structure fabrication capabilities. However, additive manufacturing characteristics such as high porosity, anisotropy and continuous fiber content significantly affect the mechanical properties of printed parts. The aim of this study is to investigate the influence of hybrid printing of short and continuous carbon fibers on the mechanical properties and failure mechanisms of composites and to develop a model to predict elastic properties considering porosity. First, mechanical testing and characterization of short and continuous fiber reinforced polyamide (nylon) print filaments are performed. The results indicate that the elastic modulus and ultimate strength of continuous carbon fiber filaments reach 60 GPa and 1500 MPa, respectively, while the strength and elastic modulus of short carbon fiber filaments reach 60 MPa and 1 GPa, respectively. Then tensile specimens with different continuous fiber orientations and different continuous fiber placement sequences are printed and tested using a multi-material 3D printing technique. The specimens are characterized before and after testing using scanning electron microscopy and microscopy to assess the porosity and failure mechanisms of specimens with different configurations. The results show that the mechanical properties of the printed parts are much lower than those of the print filaments, which proves the serious negative impact of the material extrusion process on the mechanical properties of the printed structural parts. Finally, an analytical method for predicting the elastic behavior of printed composites is developed by introducing the porosity factor in the volume-averaged stiffness model. For continuous and short fiber filled composites with different fiber contents and printing orientations, the predicted results are in agreement with the experiments, and the prediction error is greatly reduced from 30% to less than 5%.

A Constitutive Model for 3D Printed Continuous Fiber Reinforced Composite Structures with Variable Fiber Content

Experimental and Theoretical Studies on 3D Printed Short and Continuous Carbon Fiber Hybrid Reinforced Composites

Process evaluation, tensile properties, mathematical models, and fracture behavior of 3D printed continuous fiber reinforced thermoplastic composites

Design and 3D Printing of Continuous Fiber Reinforced Heterogeneous Composites

Three‐Point Bending Properties of 3d‐printed Continuous Carbon Fiber Reinforced Heterogeneous Composites Based on Fiber Content Gradients

Self-monitoring Continuous Carbon Fiber Reinforced Thermoplastic Based on Dual-Material Three-Dimensional Printing Integration Process

Carbon Fiber-Thermoplastic Composite 3D Printing Technology and Its Self-Monitoring

Multi-scale Analysis for 3D Printed Continuous Fiber Reinforced Thermoplastic Composites

3D printing of curvilinear fiber reinforced variable stiffness composite structures: A review

An investigation into mechanical properties of a 3D printed two-matrix continuous fiber composites with multi-cavity structure

Investigation on the mechanical properties of 3D printed hybrid continuous fiber-filled composite considering influence of interfaces

Interfacial constitutive model of 3D printed fiber reinforced concrete composites and its experimental validation

Evaluation and Prediction of Tensile Properties of 3d‐printed Continuous Carbon/kevlar Fiber‐filled Composites by Coaxial Hybrid Process

Process-dependent Multiscale Modeling for 3D Printing of Continuous Fiber-reinforced Composites

Multiscale Computational Modeling of 3D Printed Continuous Fiber-Reinforced Composites

Novel Designable Strategy and Multi-Scale Analysis of 3D Printed Thermoplastic Fabric Composites

3D Printed Continuous Fibre Reinforced Composite Corrugated Structure

Progressive concurrent topological optimization with variable fiber orientation and content for 3D printed continuous fiber reinforced polymer composites

Mechanical Characterization of 3D Printed Continuous Carbon Fiber Reinforced Thermoplastic Composites

Strain rate dependence of 3D printed continuous fiber reinforced composites

Experimental analysis of 3D printed continuous carbon/glass hybrid fiber reinforced PLA composites: Revealing synergistic mechanical properties and failure mechanisms