Abstract:The term Shear Transformation Zone (STZ) refers to the atomic cluster that dissipates external stress through cooperative shear. The STZ is the process that describes the local atomic rearrangement mechanism of metallic glasses (MGs). Based on the cooperative shear model (CSM), the size of an STZ has been estimated using the rate jump method (RJM), nano-scale creep method (NCM), first pop-in statistical method (FSM) and serration-flow statistic method (SSM), respectively. In the nanoindentation process, different sizes of STZs can be elicited by employing different experimental conditions (indentation depth and loading rate). In addition, different characterization methods exhibit various degrees of response to changes in the experimental conditions. In order to study the heterogeneity of the STZ of MGs using different nanoindentation methods, in this study, three types of Zr-based MGs with different Poisson's ratios were used as the research objects, and the sizes of the STZs of these amorphous alloys were calculated using the previously mentioned methods. By applying different maximum loads and loading rates, the effect of the nanoindentation test parameters on the size of the metallic glasses' STZs were characterized using different nanoindentation methods. Under the same testing conditions, the volume of the STZs was calculated using each method that exhibited improvement with the increase of the Poisson's ratio. The calculated results obtained using the RJM, NCM and SSM were found to be much greater than those obtained using the FSM. With the increase in the loading rate, the results obtained using NCM decreased, whereas the statistic method results slightly increased. At the maximum load, the STZ volume calculated using the JRM, NCM and SSM increased significantly. The FSM was not affected by the maximum load. Finally, these differences are discussed from the aspects of the calculation principles and the activation and evolution of the STZ.

Berkovich Nanoindentation of Zr55Cu30Al10Ni5 Bulk Metallic Glass at a Constant Loading Rate

The Effect of Free Volume on the Deformation Behaviour of a Zr-based Metallic Glass under Nanoindentation

Effect of nanoindentation experimental parameters on the estimation of the plastic events in metallic glasses employing various analysis methods

Room-temperature nanoindentation measurements of La-based bulk metallic glass

The effects of elastic cycling in nanoindentation of a metallic glass

On the Contact Area for Nanoindentation Tests with Berkovich Indenter: Case Study on Soda-Lime Glass

Microstructural evolution and analysis of Zr–Co/Cu–Al glassy composites and crystallized alloys via indentation and MD simulations

On the crystallographic anisotropy of plastic zone size in single crystalline copper under Berkovich nanoindentation

Study of mechanical deformation in bulk metallic glass through instrumented indentation

Nanoindentation and relaxation behavior of nitrogen doped zirconium based bulk metallic glass

Plasticity in cyclic indentation of a Cu-Zr-based bulk metallic glass after tensile loading: An experimental and molecular dynamics simulation study

High strain rate sensitivity of hardness in Ti-Zr-Hf-Be-(Cu/Ni) high entropy bulk metallic glasses

Length scale dependent plasticity of amorphous/amorphous NiNb/ZrCuNiALSI nanolaminates

Nanoindentation-induced evolution of atomic-level properties in silicate glass: Insights from molecular dynamics simulations

Effects of pre-strain on the nanoindentation behaviors of metallic glass studied by molecular dynamics simulations

Instrumented indentation study of plastic deformation in bulk metallic glasses

Nanoindentation‐induced evolution of atomic‐level properties in silicate glass: Insights from molecular dynamics simulations

A criterion of the critical threshold of the maximum shear stress in bulk metallic glasses with cryogenic thermal cycling by statistics in nanoindentation

Structure and size of the plastic zone formed during nanoindentation of a metallic glass

Depth-sensing ductile and brittle deformation in 3C-SiC under Berkovich nanoindentation

Role of densification in deformation behaviors of model metallic glasses under 3-D nanoindentation studied in molecular dynamics simulation