Abstract:In this work, a polymer precursor was first synthesized using p-terphenyl (TP) and terephthaloyl chloride (TC) as monomers. Then, cross-linking was realized by means of a Schiff base reaction with melamine (MA) as a modifier to obtain an amine-functionalized porous organic polymer TP-TC-MA. The synthesized polymers were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), Fourier transform infrared (FT-IR) spectroscopy, X-ray diffraction (XRD), and point of zero charge (pHpzc) measurements, as well as on the basis of nitrogen adsorption-desorption isotherms. Adsorption experiments were carried out to evaluate the adsorption properties of TP-TC-MA for methyl orange (MO), a typical anionic azo dye that has widespread industrial application. The amount of MO adsorbed on TP-TC-MA was evaluated by ultraviolet-visible (UV-Vis) spectroscopy at a wavelength of 463 nm. Microscopic analysis revealed that the as-synthesized polymer had an aggregated particle-shaped structure. XRD spectra confirmed that TP-TC-MA was an amorphous polymer, consistent with the results of high-resolution TEM experiments. The Brunauer-Emmett-Teller (BET) specific surface area and total pore volume of TP-TC-MA were determined as 708.5 m 2/g and 0.556 cm3/g, respectively. The measured pHpzc of TP-TC-MA was 4.0, probably because of the abundant nitrogen-containing groups provided by MA. The factors affecting adsorption, such as pH, adsorbent dosage, contact time, initial pollutant concentration, and ionic strength, were investigated. Because of the protonation of the N-atom in TP-TC-MA, the pH had a strong impact on the adsorption of MO. The removal efficiency could be maximized at the optimized pH of 3.0. The adsorption equilibrium isotherm, measured at 25 ℃ and a concentration of 50-500 mg/L, showed that the MO adsorption over TP-TC-MA followed the Langmuir isotherm, with a maximum adsorption capacity of 156.3 mg/g. The modeling of the experimental adsorption data was consistent with the pseudo-second-order kinetic model, which indicated fast adsorption and chemisorption as the dominant mechanism. With increasing ionic strength, the adsorption of MO slightly decreased, suggesting a partial antagonistic ion effect. Results of the selectivity study revealed that TP-TC-MA was more selective toward MO than methylene blue (MB), which indicated that electrostatic interactions played a significant role during the adsorption progress. Five adsorption-desorption cycles showed that TP-TC-MA could be regenerated without significant deterioration of its adsorption efficiency, indicating that it has good stability and reusability. The observed adsorption performance indicated that this MA-modified porous organic polymer offers prospects for further research and application in the treatment of dye-containing wastewaters.

Modified Fruit Pericarp As an Effective Biosorbent for Removing Azo Dye from Aqueous Solution: Study of Adsorption Properties and Mechanisms

Insights into Mass Transfer Mechanism and Micro-Interaction of Melanoidin Adsorption on Polyethyleneimine-Functionalised Pomelo-Peel-derived Aerogel

Mussel-inspired polydopamine decorated pomelo peel as a durable biosorbent for adsorption of cationic dyes

[Preparation of melamine-functionalized porous organic polymer and its adsorption properties for methyl orange]

Mino-modified biomass for highly efficient removal of anionic dyes from aqueous solutions

The neuronal architecture of the cochlear nucleus of the cat

Sustainable use of low-cost adsorbents prepared from waste fruit peels for the removal of selected reactive and basic dyes found in wastewaters

Surface modification of Penicillium chrysogenum mycelium for enhanced anionic dye removal

Utilization of dried fruit peels from prickly pears as an eco-friendly bio-sorbent for adsorption and removing certain cationic dyes from water samples

A Novel Low-Cost Bio-Sorbent Prepared from Crisp Persimmon Peel by Low-Temperature Pyrolysis for Adsorption of Organic Dyes

Unripe Plantain Peel Biohydrogel for Methylene Blue Removal from Aqueous Solution

Study on the Biosorption Mechanism of Methylene Blue in Aqueous Solution Using Pummelo Peel

Bio-based adsorption foam composed of MOF and polyethyleneimine-modified cellulose for selective anionic dye removal

Removal of Dye from Aqueous Solution Using Ectodermis of Prickly Pear Fruits-Based Bioadsorbent

Polyelectrolyte electrostatically self-assembled modified porous polyacrylonitrile nanofibers as adsorbents for anionic dye removal

High adsorption capacities for dyes by a pH-responsive sodium alginate/sodium lignosulfonate/carboxylated chitosan/polyethyleneimine adsorbent

Removal of sulfonated azo Reactive Red 195 textile dye from liquid phase using surface-modified lychee (Litchi chinensis) peels with quaternary ammonium groups: Adsorption performance, regeneration, and mechanism

Efficient adsorption of methyl red, methyl orange and bromothymol blue by polyamine resin: Role of linearity and size of carboxylate in enhanced encapsulation and molecular matching

Ultra-high efficient pH induced selective removal of cationic and anionic dyes from complex coexisted solution by novel amphoteric biocomposite microspheres

Adsorption of anionic and cationic azo dyes from wastewater using novel and effective multicomponent adsorbent

Microwave assisted synthesis of polyacrylamide grafted gum ghatti and its application as flocculant.