Abstract:Eelectric Vehicles $(EV_{s})$ have developed fastly supported by governments to relieve pollution issues and energy crisis in recent years. However, with the continuous devlopment of $EV_{s}$, efficient and rapid charging will restrict its further development. So a kind of charging module which owns high-output power and high-efficiency is a feasible key to solve the charging problem. However, conventional charging modules with using Silicon (Si) devices couldn’t realize very high efficiency, as a lot of power losses caused by power semiconductors and magnetic devices. So reducing power loss of these devices is a useful way to realize very high efficiency. Hence, this paper plans to design a 15kW DC/DC converter with LLC topology and Silicon-Carbide (SiC) devices to reduce power loss and verify its high efficiency. The proposed converter could reach about 98.4% and higher about 3% than conventional converter at rated full-load condition. Power density and volume of this proposed converter increases 27.6% and decreases 21.9% than conventional converter, respectively. Other detailed comparison information about this two converters shown as Part-D of section-II in this paper. In the end, relaive experimental waveforms used to verify the correctness and rationality of design.

High-power DC--DC Converter Based on SiC Power Device

Research on High Efficiency DC/DC Converter in Grid-connected Fuel Cell Distributed Power System

Soft-switching SiC Power Electronic Conversion for Distributed Energy Resources and Storage Applications

Performances of DC-DC converter for fuel cell vehicle based on SiC and Si device

A High Efficiency Two-Stage ZVS AC/DC Converter with All SiC MOSFET

Current-fed DC/DC Converter with Reverse Block IGBT for Fuel Cell Distributing Power System

Research on High Efficiency and High Boost Ratio DC Converter for Fuel Cell

ZVS range extension of 10A 15kV SiC MOSFET based 20kW Dual Active Half Bridge (DHB) DC-DC converter

High Power Three-Level Rectifier Comprising SiC MOSFET & Si Diode Hybrid Power Stage

Hybrid SiC-Si DC–AC Topology: SHEPWM Si-IGBT Master Unit Handling High Power Integrated with Partial-Power SiC-MOSFET Slave Unit Improving Performance

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

High efficiency power factor correction power supply based on SiC device

An All-SiC 15 kW/L 60 kW Multiplexing Converter for Electric Vehicles

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

An Extremely High Efficient Three-Level Active Neutral-Point-Clamped Converter Comprising SiC and Si Hybrid Power Stages

Optimal Design of SiC MOSFETs for 20kw DCDC Converter

Sic Mosfet Zero-Voltage-Switching Svm Controlled Three-Phase Grid Inverter

Extreme High Efficiency Enabled by Silicon Carbide (sic) Power Devices

SiC Full-Bridge Grid-Tied Inverter with ZVS-switching

A High-efficiency DC/DC Converter with SiC Devices and LLC topology for Charging Electric Vehicles

Efficiency Improvement of Grid Inverters With Hybrid Devices