Abstract:The calculation of deflection of reinforced concrete (RC) beams generally ignores the contribution of shear deformation. However, diagonal crack will significantly reduce the effective shear stiffness of RC beams, and result in remarkable increase of shear deformation, which should not be neglected in the assessment stage. To evaluate the effective shear stiffness of diagonally cracked RC beams with stirrups, an analytical model of shear stiffness was proposed in the paper. Firstly, the shear stiffness of RC beam at stirrup yielding status was derived based on variable angle truss model. Compared to the elastic shear stiffness, the shear stiffness degradation factor was mainly influenced by the material modulus ratio, stirrup ratio and the inclination angle of strut. Secondly, based on the observed shear stiffness degradation law of shear deformation curve, a constant tangent stiffness degradation mode, which considers the influence of cracking level, was proposed. The shear increment after shear cracking was used as a quantitative indicator for the cracking level. Finally, the analytical formulas of the inclination angle and shear stiffness degradation factor were obtained based on the principle of minimum strain energy. To verify, two thin-webbed concrete beams were tested and corresponding shear deformation were carefully measured. In addition, shear deformation data of fifteen shear segments of RC beams in literature were collected. The comparison results showed that the proposed shear stiffness degradation model gives good prediction of the shear stiffness at stirrup yielding status and reflects the degradation law of shear stiffness at different cracking level.

Optimal strut-and-tie model for shear analysis of RC deep beams

Nonlinear Finite-Element Analysis of the Seismic Behavior of RC Column–Steel Beam Connections with Shear Failure Mode

Strut-And-Tie Model Research On Bridge Column-Pile-Footing

Optimum Strut-and-Tie Models for Reinforced Concrete Beams

Direct Strut-and-Tie Model for Ultimate Shear Strength of Reinforced Concrete Structural Walls

Strut-and-tie Model of Deep Beam Design Under Uniform Distributed Loads

Investigation of Optimal Layout of Ties in Stm Developed by Topology Optimization

Simplified Shear Design of Slender Reinforced Concrete Beams with Stirrups

Study on Mechanical Behaviors and Calculation of Shear Strength of Steel Truss Reinforced Concrete Deep Beams

Development of Strut‐and‐tie Models Using Topology Optimization Based on Modified Optimal Criterion

Strut-and-tie Model of Deep Beam Design Subjected to Two Movable Loads

Elastic-to-Plastic Strut-and-Tie Model for Deep Beams

A unifying strut-and-tie model for conventionally reinforced link beams

Investigation of Load-Transfer Mechanisms in Deep Beams and Corbels

Simplified Discontinuous Field Model for RC Beams with a Medium Shear Span Ratio: Experimental Study and Shear Strength Formula

Shear Deformations of RC Beams under Service Loads

PREDICTION OF SHEAR STRENGTH OF STEEL TRUSS REINFORCED CONCRETE DEEP BEAMS BASED ON SOFTENED STRUT-AND-TIE MODEL

Optimal Three-Dimensional Strut-and-tie Models for Anchorage Diaphragms in Externally Prestressed Bridges

Improved diagonal strut model and parameters determination for interior joints in RC frames

Application of Simplified Softened Strut-and-tie Model in the Design of Interior Reinforced Concrete Beam-Column Joints

ANALYTICAL MODEL FOR SHEAR STIFFNESS OF REINFORCED CONCRETE BEAM WITH STIRRUPS 1)