Abstract:Hollow fiber membranes fabricated via dry/wet phase inversion method usually have two dense skin layers,which will increase its resistance of mass transport as a support membrane. It is necessary that the dense skin layer of support membrane has been eliminated to improve separation performance of composite membrane. The excellent. chemical resistance of poly(vinylidene fluoride) (PVDF) to many acids and alkalis has made it as an attractive membrane material, and then it's often fabricated as porous hollow fiber membrane by phase inversion. In the process, the formation of the skin layer is due to the rapid exchange between solvent and coagulation, so many attempts have been made to slow it, so as to control the formation of the skin layer. In this paper, it has been found that the fabrication progress becomes unstable, and the membrane prepared has noncircular lumen, when the "weak" or "soft" coagulation is used. To increase the fabrication solution stability during membrane formation, dope viscosity was focused in this experiment. Dimethyl acetamide (DMAc) was used as solvent as well as internal coagulant, and the additives including LiCl, water and surfactant Span were chosen to investigate their effect oil the viscosity of the fabrication solution. The dope viscosity will greatly increase after adding LiCl, while the variety of dope viscosity is unconcerned in the fabrication solution concentration as adding water. The homogenization and stability of the fabrication solution are improved by adding Span,and the viscosity increases at the same time. Without increasing PVDF concentration, the stability of the nascent membrane was improved by increasing the fabrication viscosity. The PVDF hollow fiber membrane with the structure of single outer skin layer and finger-like pore through the cross-section, has been successfully fabricated. The mean pore radius and water flux of the single skin hollow fiber membrane were greatly improved.

Investigation on Preparation and Morphology of EVOH -So3na Fabrics Membrane

Electrospun Non-Woven Mats Of Evoh

Study on the Preparation and Electro-deformation of EVOH-SO3K IPMC

Electrospinning Process and Microstructural Characterrization of Ultrafine EVOH Non-Woven

Electrospun Non-Woven Membrane of Poly(ethylene Covinyl Alcohol) End-Capped with Potassium Sulfonate

Preparation and Properties of Electrospun Soy Protein Isolate/Polyethylene Oxide Nanofiber Membranes

Preparation and Characterization of Electrospun EVOH/Ti3C2 Composite Fibers

Experimental Investigation of the Effect of Processing Parameters on the Formation of Electrospun Polyethylene Oxide Nanofibers

Influence of Dope Viscosity on the Fabrication of Pvdf Hollow Fiber Membranes with Single Skin Layer

Preparation of EVOH hydrophilic microporous membrane by thermally induced phase separation

Electrospinning And Characterization Of Nafion Nanofiber Membranes

LaMnO_3 and La_(0.875)Sr_(0.125)MnO_3 Nanofibers via Electrospinning

Experimental And Numerical Analyses On The Poly(Lactide-Co-Glycolide) Hollow Fiber Membranes

Preparation And Properties Research Of Poly(Lactide-Co-Glycolide)/Silk Blend Nanofibrous Membrane

Effects Of Solution Properties On The Morphology And Diameters Of Nanofibers Fabricated By Electrospinning

Electrospinning of Soy Protein Isolate/Poly (vinyl alcohol)

Preparation and Properties of Poly (vinyl Alcohol) Nanofibers by Electrospinning

Fabrication of Porous Structure of Electro-spun PVDF Fibres

The Study On Fabrication Of Insulated Membrane By Electrospinning

Fabrication and Property Optimization of Electrostatic Spinning PVDF/PDMS Waterproof and Moisture Permeable Membrane

Preparation of nonwoven mats of poly(L-lactic acid)nanofiber via electrospinning