Abstract:Due to the insensitive charge inside the underwater target and the thin-walled flying target in the air, it is difficult for the traditional insensitive penetrator to detonate the low vulnerability charge. The multi-effect penetrator is an effective way to detonate the low vulnerability shielding charge. In order to analyze the damage characteristics of the new energetic penetrator containing Al/PTFE energetic powder penetrating the thin-walled shielding charge shell to the internal low vulnerability injection charge, the material with mechanical properties similar to the injection charge was selected to replace the internal low vulnerability charge, and conduct research on the simulated shielding charge target composed of a new type of energetic penetrator 2A12 shell filled with PMMA. The results indicate that when the internal stress of the simulated charge reaches the maximum tensile strength of 50 MPa, the material fails and fractures, accompanied by radial cracks inside. When the penetration speed of the penetrator is between 100 and 250 m/s, it can be embedded in the aluminum plate. When the penetration speed is greater than 250 m/s, the penetrator can penetrate the aluminum plate. The total time required for the energy generated by piezoelectric ceramics to reach the ignition point is approximately 0.41–2.8 μs. The time from the moment when the counterweight hits the piezoelectric ceramic to the ignition time of the ignition head is 4–7 μs. The delay time for electric ignition head to ignite energetic powder is 365 μs. When the charge of energetic powder reaches 3 g, the overpressure at the nozzle of the energetic penetrating body can reach 1.914 GPa, the overpressure generated by the spray flame on the simulated charge can reach 1.136 GPa, the overpressure generated by the spray flame on the simulated charge can reach 1.136 GPa, and the temperature rise generated by the spray flame can reach 5560 K.

Layer counting detonating control method for fuze based on penetration overload numerical simulation

Strain-rate-dependent Cohesive Zone Modelling of Charge Damage Behavior when a Projectile Penetrates Multilayered Targets

Analysis of the influence of different initial velocities on dynamic performance of multi-layer hard target penetration process

Numerical Simulation and Analysis of Shelled Explosive Penetrated but Not Detonated

Response Amplification Study of the Simulated Projectile under Typical Boundary Conditions

NUMERICAL SIMULATION OF SHELLED EXPLOSIVE PENETRATED BUT NOT DETONATED BY LOW-DENSITY JET

Innovation of control technology for smart fuzes: precise detonation and efficient damage via a ternary cascade controller

Penetration Analysis of Driving Weapons Precursory Shaped Charge Based on LS-DYNA

Structural Design of MEMS Acceleration Sensor Based on PZT Plate Capacitance Detection

Penetration and jet flame effects induced by the interaction between a new energetic penetrator and a simulated shielding charge

Reaction degree of composition B explosive with multi-layered compound structure protection subjected to detonation loading

Advancements in research on high-overload impact-buffering protective materials

Optimal Falling Track Design for Twice detonating Fuze of Double event Fuel air Explosive with High Speed

Numerical Simulation of the Blast Wave of a Multilayer Composite Charge

Analysis and experiment of stress concentration in penetration fuze buffer materials under stress wave incursion

Simulation and Test of a MEMS Arming Device for a Fuze

Scaled Experiment of the Detonation Control System for the High-Speed Penetration on Concrete

A COUPLED FINITE DIFFERENCE MATERIAL POINT METHOD AND ITS APPLICATION IN SECURITY PROTECTION

Failure Mechanism of Multilayer Ceramic Capacitors under Transient High Impact

Experimental and numerical study on the flight and penetration properties of explosively-formed projectile

Numerical Simulation of the Effect of Blast Shock Wave on Target Plate