Abstract:This article focuses on evaporative falling film heat transfer through numerical simulations. A two-dimensional symmetric liquid film flowing outside a single horizontal tube was simulated using the open-source CFD software OpenFOAM. The Tanasawa model was employed to consider mass transfer at the liquid–vapour interface, and the isoAdvector VOF method was used for interface tracking. The simulations explored the impact of film flow rate, tube surface heat flux, and tube diameter on the liquid film thickness and surface heat transfer coefficient. Additionally, the critical heat flux and operational limits were considered. The results demonstrate the accurate reproduction of evaporative falling film heat transfer performance by the present model. The film thickness exhibits a similar profile to adiabatic and sensible falling film heat transfer but provides smaller values. Similarly, the evaporative heat transfer coefficient exhibits significantly higher values and a gentle peripheral variation. The influence of heat flux on evaporative falling film heat transfer is contingent on the film flow rate; it can either enhance or weaken the process. Notably, a larger tube diameter negatively affects heat transfer, suppressing the impact of heat flux, and also increases the risk of liquid film dryout. For a given film flow rate, the average heat transfer coefficient increases initially, reaches a maximum value, and then decreases as the wall heat flux is increased. The peak heat flux, termed critical heat flux, increases with film flow rate but decreases with tube diameter. An operational limit exists where the heat flux is lower than the critical heat flux and the film flow rate is higher than the critical film flow rate; under these conditions, evaporative falling film heat transfer operates in a fully wetting status.

Numerical Simulation of Co-Current Gas-Liquid Vertical Liquid Film Flow

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Experimental and Numerical Investigation on Gravity-Driven Film Flow over Triangular Corrugations

CFD Simulation of Gas-Liquid Flow in Bubble Column

A Volume of Fluid Method Algorithm for Simulation of Surface Tension Dominant Two-Phase Flows

Numerical simulation of oscillatory falling liquid film flows

Flow Characteristics of Film Flow over 3D Corrugations Column Plate

Numerical Simulation for Two-Dimensional Surface Wave Structure of a Vertical Liquid Falling Film

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Simulation of the hydrodynamics and mass transfer in a falling film wavy microchannel

CFD simulation of bubble column with vertical bundle internals

Numerical investigation on the longitudinal distribution characteristics of falling film flow outside a vertical tube

NUMERICAL SIMULATION OF THE FLOW WITH CONTACT LINES

NUMERICAL SIMULATIONS OF GAS-LIQUID STRATIFIED FLOW IN A HORIZONTAL PIPE WITH GAS INJECTION THROUGH WALL

Numerical Study of Falling Film Flow on a Horizontal Rotating Tube

Numerical Simulation and Experimental Study of Two-Phase Flow in a Vertical Pipe

Modelling of evaporative falling-film heat transfer over a horizontal tube

Numerical and experimental investigation of dripping and jetting flow in a coaxial micro-channel

Numerical simulation of falling film evaporation of binary mixture

Falling film flow and heat transfer on a horizontal tube under the shearing of vertical vapor