Abstract:A digital deconvolution method with pile-up reconstruction has been proposed for scintillator detectors for high rate photon-counting X-ray imaging applications. The detector signal was modeled as an exponential decay waveform convoluted with the single photon response of the SiPM detector. An impulse signal can be obtained by digital deconvolution (unfolding) with much shorter duration, which was then used for energy estimation followed by a trapezoid filter and pile-up discrimination The whole digital deconvolution algorithm has been synthesized and verified by both SIMULINK simulation and experimental tests. The prototype of the detector and the readout electronics were developed for demonstration, using 3 mm x 3 mm x 10 mm LYSO scintillator coupled with a 3 mm x 3 mm SenSL SiPM. A 14 bit, 100 MSPS ADC was used to sample the analog waveform and the digital filter was implemented in a Xilinx Kintex 7 FPGA. The signal width was shortened from similar to 250 ns to 10 similar to 20 ns and then was shaped into trapezoidal pulse with 100 ns width. The energy was estimated from the trapezoid top for better signal collection and noise rejection. The unfolded pulses were used for pile-up discrimination and to reconstruct two pile-up signals from the overlapped trapezoid outputs. The energy performance of the prototype system was firstly validated by measuring the energy spectrums of Am-241, Co-57, Na-22 and Cs-137 radiation sources. The energy resolutions were measured to be 36.9%, 29.9%, 13.9% and 12.9% respectively at 59.5 keV, 122 keV, 511 keV and 662 keV in FWHM. High rate performance was evaluated by an X-ray generator. The maximum output counting rate was measured to 5.36 Mcps without saturation, comparing with the saturated counting rate of 2.34 Mcps using the original LYSO signals The saturation counting rate using digital deconvolution was estimated to be up to similar to 7 Mcps fitted with the paralyzable dead time model, corresponding to similar to 20 Mcps input count rate.

The mathematical model for ID-201 semiconductor single photon counter

The Photon Detection Mode of Photomultiplier Tubes Considering the Pulse Height Distribution

Photocounting measurements with dead time and afterpulses in the continuous-wave regime

TH‐CD‐207B‐07: Noise Modeling of Single Photon Avalanche Diode (SPAD) for Photon Counting CT Applications

Detection of ultra-weak laser pulses by free-running single-photon detectors: Modeling dead time and dark counts effects

Characterization of an InGaAs/InP single-photon detector at 200 MHz gate rate

Modeling Charge Transport in Photon-Counting Detectors

Digital Deconvolution Of Scintillation Detector Signals For High Rate Photon-Counting X-Ray Imaging Applications

On the basic mechanism of Pixelized Photon Detectors

Photocounting statistics of superconducting nanowire single-photon detectors

Mathematical model of potential distribution in a pinned photodiode of an indirect time of flight CMOS image sensor

Dark current and single photon detection by 1550 nm avalanche photodiodes: dead time corrected probability distributions and entropy rates

The photon detection mode and performance analysis of SiPM photon counting Lidar under different discrimination thresholds

A Count-Rate Recovery Method for Photon Counting X-ray Detectors Using Scintillator/SiPM

Numerical analysis of In_(0.53) Ga_(0.47) As/InP single photon avalanche diodes

A Monte Carlo assessment of the spectral performance of four types of photon counting detectors

Design of Photon-counting Detection and Imaging Experimental Setup

Dark Current and Single Photon Detection by 1550nm Avalanche Photodiodes: Dead Time Corrected Probability Distributions and Entropy Rates

The Performance of Photon Counting Imaging with A Geiger Mode Silicon Avalanche Photodiode

Exact solutions for silicon photomultipliers models and application to measurements