Time Correlated Single-Photon Counting (Tcspc) Using Laser Excitation
D. Phillips,R.C. Drake,D.V. O'Connor,R.L. Christensen
DOI: https://doi.org/10.1080/10739148508543581
1985-01-01
Abstract:The basic methods of time-correlated single-photon counting are outlined briefly, and the advantages of rapid repetition-rate pulsed lasers as light sources in this experiment are outlined. Application of the method to time-resolved fluorescence anisotropy is described. The basic principles of time-correlated single-photon counting have been the subjects of many reviews1-6. The method relies on the basic concept that the probability distribution for emission of a single-photon following excitation gives the actual intensity against time distribution of all photons emitted, thus by sampling the time of single-photon emission following a large number of excitation pulses, the probability distribution is created. The experiment is carried out as follows, with reference to Figure 1. A trigger T. which could be a photomultiplier, an antenna pick-up, or a logical synchronising pulse from the electronics pulsing the excitation source, generates an electrical pulse at a time exactly correlated with the time of generation of the optical pulse. The trigger pulse is routed, usually through a discriminator, to start input of the time-to-amplitude converter, (TAC) which initiates charging of a capacitor. In the meantime the optical pulse excites the sample, which subsequently fluoresces. An aperture is adjusted so that at most one photon is “detected” for each exciting event. The signal resulting from this photon stops the charging ramp in the TAC, which puts out a pulse, the amplitude of which is proportional to the charge in the capacitor, and hence to the time difference between START and STOP pulses. The TAC output pulse is given a numerical value in the analogue-to-digital converter and a count is stored in the data storage device in an address corresponding to that number. Excitation and data storage are repeated in this way until the histogram of number of counts against address number in the storage device has enough data so that it represents, to some required precision, the decay curve of the sample. If deconvolution is necessary, the time profile of the excitation pulse is collected in the same way by replacing the sample by a light scatterer.
chemistry, analytical,instruments & instrumentation