Abstract:Purpose:Silicon photomultiplier (SiPM) has recently emerged as a promising photodetector for biomedical imaging applications. Due to its high multiplication gain (comparable to PMT), fast timing, low cost and compactness, it is considered a good candidate for photon counting CT. Dark noise is a limiting factor which impacts both energy resolution and detection dynamic range. Our goal is to develop a comprehensive model for noise sources for SiPM sensors.Methods:The physical parameters used in this work were based upon a test SPAD fabricated in 130nm CMOS process. The SPAD uses an n+/p‐well junction, which is isolated from the p‐substrate by a deep n‐well junction. Inter‐avalanche time measurement was used to record the time interval between two adjacent avalanche pulses. After collecting 1×106 counts, the histogram was obtained and multiple exponential fitting process was used to extract the lifetime associated with the traps within the bandgap.Results:At room temperature, the breakdown voltage of the SPAD is ∼11.4V and shows a temperature coefficient of 7.7mV/°C. The dark noise of SPAD increases with both the excess biasing voltage and temperature. The primary dark counts from the model were validated against the measurement results. A maximum relative error of 8.7% is observed at 20 °C with an excess voltage of 0.5V. The probabilities of after‐pulsing are found to be dependent of both temperature and excess voltage. With 0.5V excess voltage, the after‐pulsing probability is 63.5% at ‐ 30 °C and drops to ∼6.6% at 40 °C.Conclusion:A comprehensive noise model for SPAD sensor was proposed. The model takes into account of static, dynamic and statistical behavior of SPADs. We believe that this is the first SPAD circuit simulation model that includes the band‐to‐band tunneling dark noise contribution and temporal dependence of the after‐pulsing probability.

Why Has Work Effort Become More Intense?

A Pinned Photodiode Analytic Model Enabling Opto-Electronic Circuit Simulation

The Photon Detection Mode of Photomultiplier Tubes Considering the Pulse Height Distribution

Charge Transfer Potential Barrier Model of a Pinned Photodiode in CMOS Image Sensors

Analysis and Fabrication of A New Two Dimensional Near Infrared Pincushion Silicon Based Psd

A Drift-Diffusion Model of Pinned Photodiode Enabling Opto-Electronic Circuit Simulation

Double Junction Photodiode for X-Ray Cmos Sensor Ic

Pinning voltage model of vertical pinned photodiode for Dual-Pixel image sensor

A simulation study of electric field engineering with multi-level pinned photodiodes for fast and complete charge transfer

MOS-based model of four-transistor CMOS image sensor pixels for photoelectric simulation

Characterization of SOI pixel sensor using pinned depleted diode structure with AC-coupling on the diode

Impact of dark current on pinned photo-diode capacitance of CMOS image sensor in low illumination regime

Pathogenesis of diethylnitrosamine-induced tumors in the trachea of the Syrian golden hamster.

Analysis of Light Intensity and Charge Holding Time Dependence of Pinned Photodiode Full Well Capacity

On the basic mechanism of Pixelized Photon Detectors

Simulations and Design of a Single-Photon CMOS Imaging Pixel Using Multiple Non-Destructive Signal Sampling

Investigation of proton single-event transient in CMOS image sensor

TH‐CD‐207B‐07: Noise Modeling of Single Photon Avalanche Diode (SPAD) for Photon Counting CT Applications

An analytical model of energy response function for CdTe-based photon counting detectors with inter-pixel communication for anti-coincidence corrections

A Two-Tap Indirect Time-of-Flight CMOS Image Sensor With Pump Gate Modulator for Low-Power Applications

Study of the internal mechanisms of Pixelized Photon Detectors operated in Geiger-mode