Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Flow of Nanofluid and Thermal Radiation in a Microchannel

Flow and Heat Transfer of Nanofluid Through a Horizontal Microchannel with Magnetic Field and Interfacial Electrokinetic Effects

Numerical study of the effects of nanorod aspect ratio on Poiseuille flow and convective heat transfer in a circular minichannel

Convective Heat Transfer and Resistance Characteristics of Nanofluids with Cylindrical Particles

Numerical Research on Convective Heat Transfer and Resistance Characteristics of Turbulent Duct Flow Containing Nanorod-Based Nanofluids

Investigation on Flow and Heat Transfer of Nanofluids by the Thermal Lattice Boltzmann Model

Influence of Interfacial Electrokinetic on MHD Radiative Nanofluid Flow in a Permeable Microchannel with Brownian Motion and Thermophoresis Effects

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

Numerical Study on the Microflow Mechanism of Heat Transfer Enhancement in Nanofluids

The nanofluid flows in the channel with linearly varying wall temperature

Effects of nanofluid and radiative heat transfer on the double-diffusive forced convection in microreactors

Nanofluid Flow and Heat Transfer in a Microchannel with Interfacial Electrokinetic Effects

Numerical Analysis of Flow and Heat Transfer Characteristics in Micro-channels

Numerical investigation of turbulent flow and heat transfer of nanofluid inside a wavy microchannel with different wavelengths

FLOW AND HEAT TRANSFER BEHAVIORS OF WATER-BASED NANOFLUIDS CONFINED IN NANOCHANNEL BY MOLECULAR DYNAMICS SIMULATION

Numerical investigation on forced convection in rectangular cross section micro-channels with nanofluids

Numerical Simulation of Nanofluid Flow and Heat Transfer in a Microchannel: the Effect of Changing the Injection Layout Arrangement

On the Microscopic Flow Characteristics of Nanofluids by Molecular Dynamics Simulation on Couette Flow

LAMINAR FLOW AND HEAT TRANSFER IN MICRO－ANNULAR CHANNEL IN SLIP FLOW REGIME

Flow and Heat Transfer Simulations for Nanofluids with Nanoparticles of Various Diameters by Molecular Dynamics Method

Heat Transfer Enhancement and Entropy Generation of Nanofluids Laminar Convection in Microchannels with Flow Control Devices.