Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

The nanofluid flows in the channel with linearly varying wall temperature

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Convective Heat Transfer and Resistance Characteristics of Nanofluids with Cylindrical Particles

Analysis of Error and Stability of Nanofluid over Horizontal Channel with Heat/Mass Transfer and Nonlinear Thermal Conductivity

Numerical study of the effects of nanorod aspect ratio on Poiseuille flow and convective heat transfer in a circular minichannel

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

A Molecular Dynamics Simulation on the Convective Heat Transfer in Nanochannels

Peristaltic Flow and Heat Transfer of Nanofluids in a Sinusoidal Wall Channel: Two-Phase Analytical Study

An Analytical Solution of Convective Heat Transfer in Microchannel or Nanochannel

FLOW AND HEAT TRANSFER BEHAVIORS OF WATER-BASED NANOFLUIDS CONFINED IN NANOCHANNEL BY MOLECULAR DYNAMICS SIMULATION

Planar Couette flow of power law nanofluid with chemical reaction, nanoparticle injection and variable thermal conductivity

Flow and heat transfer of nanofluids in a cylindrical permeable wavy channel embedded in porous medium using Buongiorno's model

Flow And Heat Transfer Enhancement Of Nanofluids In Microchannel With Blocks And Grooves

Analysis of Fully Developed Opposing Mixed Convection Flow in an Inclined Channel Filled by a Nanofluid

Numerical investigation of heat transfer and fluid flow characteristics inside a wavy channel

Impacts of two-phase nanofluid approach toward forced convection heat transfer within a 3D wavy horizontal channel

Molecular Dynamics Simulations of Coupling Between Flow and Heat Transfer in A Nanochannel

A Solid-Liquid Local Thermal Non-Equilibrium Lattice Boltzmann Model for Heat Transfer in Nanofluids. Part II: Natural Convection of Nanofluids in a Square Enclosure

A numerical investigation of transient natural convection heat transfer of aqueous nanofluids in a differentially heated square cavity

Numerical Investigation of Unsteady Multiphase Nanofluid-Free Convection Flow About a Vertical Cylinder With Non-Uniform Temperature

Cattaneo-Christov double diffusion based heat transport analysis for nanofluid flows induced by a moving plate