Abstract:An unsteady Reynolds averaged Navier–Stokes (URANS) method combined with a rigid dynamic mesh technique was developed to simulate unsteady flows around complex configurations during pitching motion. First, a test case with the NACA0012 airfoil was selected to validate the numerical methods and our in-house codes. Then, we evaluated the unsteady flows around an advanced aircraft model during harmonic pitching motion at high incidence. The effects of pitching motion on the hysteresis of aerodynamic force, the evolution of the leading-edge vortex, and the distribution of pressure on the model’s surface were analyzed in detail. The roles of several significant parameters such as the reduced frequency and pitching amplitude were revealed. Several conclusions were found: pitching motion would delay the initiation of the leading-edge vortex, strengthen the vorticity, postpone the occurrence of vortex breakdown, and weaken the massively separated flows, thus causing additional aerodynamic force. Two categories of critical reduced frequency have been found, which divide the influence of reduced frequency on aerodynamic force into three stages, called the linear increasing range, slowly increasing range, and constant range. The first-order phase lag between the aerodynamic force and the incidence is a constant that is independent of the amplitude when the reduced frequency is sufficiently high. A scaled maximum value of C L is proposed; it depends only on the reduced frequency (instead of the amplitude), and increases linearly when the reduced frequency is sufficiently low.

Numerical investigation on aerodynamic performance of a standard model CHN-T1 using an unstructured flow solver

Experimental Validation of Nonlinear Coupled Constitutive Relations in Continuum Flows

Constrained Large-Eddy Simulation and Detached Eddy Simulation of Flow Past a Commercial Aircraft at 14 Degrees Angle of Attack

Numerical Simulation of Hypersonic Thermochemical Nonequilibrium Flows Using Nonlinear Coupled Constitutive Relations

Validation and Analyses of QCR Correction Turbulence Model in Sub-/Super-sonic Inner Flows

Computation of Hypersonic Flows over Flying Configurations Using a Nonlinear Constitutive Model

Numerical Investigation on Local Non-equilibrium Flows Using a Diatomic Nonlinear Constitutive Model

Computational Simulation of Reentry Flows over Hypersonic Vehicles Using Nonlinear Coupled Constitutive Relations

NUMERICAL SIMULATION OF THE AERODYNAMIC PERFORMANCE OF A SINGLE-STAGE TURBINE AT OFF-DESIGN WORKING CONDITIONS

Research on precise and standardized numerical simulation strategy for vehicle aerodynamics

Numerical Investigations Of The Jaxa High-Lift Configuration Standard Model With Mflow Solver

Numerical Simulation of Atmospheric Boundary Layer Turbulence in a Wind Tunnel Based on a Hybrid Method

Numerical Simulation Research on the Aerodynamic Characteristics of CHNT1 Standard Model in Heavy Gas Environment

Numerical Simulation on the Flow Field in Vehicle Climate Wind Tunnel

Study of Transonic Separated Flows with zonal-DES Based on Weakly Non-linear Turbulence Model

Numerical validation of aerodynamics for two in-line model wind turbines using actuator line model and CFD technique

NUMERICAL SIMULATION FOR PNEUMATIC CHARACTERISTICS FOR TWO-DIMENSIONAL AIRFOILS LARGE WIND TURBINE

Aerodynamic Analysis and Design Numerical Simulation of the Vortex Flow over a Common Research Model with Flying-Wing Configuration

Numerical investigation of an advanced aircraft model during pitching motion at high incidence

Analysis of Turbulent Separated Flows for the NREL Airfoil Using Anisotropic Two-Equation Models at Higher Angles of Attack

Assessment of turbulence models and mesh types for the simulation of multi-body separation by coupling the CFD and rigid body dynamics