Abstract:Determination of the distribution of a generated acoustic field is valuable for studying ultrasonic transducers, including providing the guidance for transducer design and the basis for analyzing their performance, etc. A method calculating the acoustic field based on laser-measured vibration velocities on the ultrasonic transducer surface is proposed in this paper. Without knowing the inner structure of the transducer, the acoustic field outside it can be calculated by solving the governing partial differential equation (PDE) of the field based on the specified boundary conditions (BCs). In our study, the BC on the transducer surface, i.e. the distribution of the vibration velocity on the surface, is accurately determined by laser scanning measurement of discrete points and follows a data fitting computation. In addition, to ensure the calculation accuracy for the whole field even in an inhomogeneous medium, a finite element method is used to solve the governing PDE based on the mixed BCs, including the discretely measured velocity data and other specified BCs. The method is firstly validated on numerical piezoelectric transducer models. The acoustic pressure distributions generated by a transducer operating in an homogeneous and inhomogeneous medium, respectively, are both calculated by the proposed method and compared with the results from other existing methods. Then, the method is further experimentally validated with two actual ultrasonic transducers used for flow measurement in our lab. The amplitude change of the output voltage signal from the receiver transducer due to changing the relative position of the two transducers is calculated by the proposed method and compared with the experimental data. This method can also provide the basis for complex multi-physical coupling computations where the effect of the acoustic field should be taken into account.

Study on Computing of Resonance Frequency of Resonance Pipes

Study on resonance frequency of thermoacoustic resonance pipes

A Study on Finite Amplitude Standing Waves in Stepped Acoustic Resonator

Discussion on resonant frequency in thermoacoustic systems

Study on Nonlinear Acoustic Waves in Stepped Acoustic Resonators

Study on measurement technology of dynamics characteristics of typical tubes for pressure measurements

Numerical Simulation and Structure Optimization of Compressor Muffler

Numerical Analysis of Acoustic Characteristic of Muffler with Complicated Structure and Structural Optimization

Finite Element Method Simulation Analysis for Sound Field of Exhaust Muffler

Numerical Analysis and Structure Improvement of Automotive Exhaust Muffler's Acoustic Characteristics

Numerical Analysis Of Noise Radiation Of Compressor Shell Considering Lubrication Oil

Computer Simulation Model for Room Diffuse Sound Field

Numerical simulation and test validation for performance of a muffler in an exhaust pipe

Theoretical Study on a Water Muffler

Calculation of Acoustic Field Based on Laser-Measured Vibration Velocities on Ultrasonic Transducer Surface

A simplified analytical model for the investigation of contact acoustic nonlinearity in pipe structures

Analysis and Experimental Study on the Measurement of Pipe Wall Thinning by Perturbation Method

A Computational Fluid Dynamics Approach for Full Characterization of Muffler Without and with Exhaust Flow

Performance optimization of thermoacoustic systems by measurement with two-microphone method

Coupling Between Thermoacoustic Resonance Pipes and Piezoelectric Loudspeakers Studied by Equivalent Circuit Method

Sound radiation at the nozzle of a pipeline system and noise reduction based on a non-anechoic pool