Abstract:A coaxial-output capacitor-loaded annular pulse forming line (PFL) is developed in order to reduce the flat top fluctuation amplitude of the forming quasi-square pulse and improve the quality of the pulse waveform produced by a Tesla-pulse forming network (PFN) type pulse generator. A single module composed of three involute dual-plate PFNs is designed, with a characteristic impedance of 2.44 Omega, an electrical length of 15 ns, and a sustaining voltage of 60 kV. The three involute dualplate PFNs connected in parallel have the same impedance and electrical length. Due to the existed small inductance and capacitance per unit length in each involute dual-plate PFN, the upper cut-off frequency of the PFN is increased. As a result, the entire annular PFL has better high-frequency response capability. Meanwhile, the three dual-plate PFNs discharge in parallel, which is much closer to the coaxial output. The series connecting inductance between adjacent two modules is significantly reduced when the annular PFL modules are connected in series. The pulse waveform distortion is reduced when the pulse transfers along the modules. Finally, the shielding electrode structure is applied on both sides of the module. The electromagnetic field is restricted in the module when a single module discharges, and the electromagnetic coupling between the multi-stage annular PFLs is eliminated. Based on the principle of impedance matching between the multi-stage annular PFL and the coaxial PFL, the structural optimization design of a mixed PFL in a Tesla type pulse generator is completed with the transient field-circuit co-simulation method. The multi-stage annular PFL consists of 18 stage annular PFL modules in series, with the characteristic impedance of 44 Omega, the electrical length of 15 ns, and the sustaining voltage of 1MV. The mixed PFL can generate quasi-square electrical pulses with a pulse width of 43 ns, and the fluctuation ratio of the pulse flat top is less than 8% when the pulse rise time is about 5 ns. Published by AIP Publishing.

Design of Square Pulse Linear Transformer DriverModule With Two-Layer Coaxial Structure

Design and Simulation of Fast Linear Transformer Driver with Four Stages in Series Sharing Common Cavity Shell and Mega-Ampere Current

Conception Design of a Long-pulsed Driver Based on FLTD and RLC Snubber

300-Ka Fast Linear Transformer Driver Stage

Simulation and Primary Experimentation of Fast Linear Transformer Driver Module

Design of Compact Transmission Line Transformer for High Voltage Nanosecond Pulses

A High-Voltage Pulse Transformer with a Modular Ferrite Core.

Novel Configuration Linear Transformer Driver with Multistages in Series Sharing Common Cavity Shell

Numerical Analysis of a Single-Stage Fast Linear Transformer Driver Using Field-Circuit Coupled Time-Domain Finite Integration Theory

Primary investigation of fast linear transformer driver module

Design and Simulation of a Self-Triggering Linear Transformer Driver

A Gas-Insulated Mega-Ampere-class Linear Transformer Driver with Pluggable Bricks

Design of a Novel Self-Triggering Linear Transformer Driver

A Coaxial-Output Capacitor-Loaded Annular Pulse Forming Line

Transient Electromagnetic Field Analysis for the Single-Stage Fast Linear Transformer Driver with Two Different Configurations Using the Finite-Element Method and Finite Integration Technique

Numerical Analysis of the Output-Pulse Shaping Capability of Linear Transformer Drivers

Development of Linear Transformer Driver

Four-Stage Linear Transformer Driver with Sharing Shell: EM Model, Simulation, and Performance

The Numerical Simulation of a Four-Stage Linear Transformer Driver Module Based on the Preisach Magnetic Core Model.

Development of high pulsed-power source based on linear transformer driver for direct-driven Z pinch load

Computational Investigations on the Four-Stage MA-Class Fast Linear Transformer Driver with Sharing Cavity Shell