Abstract:The unsteady flow at small flow rates is always the most important of typical unsteady phenomena in centrifugal compressors, since it is closely related to the operating safety and efficiency. To study the mechanism of stall and surge generation, an experimental research on an industrial centrifugal compressor with variable vaned diffuser is carried out to study the unsteady flow structure from design point to surge. A multi-phase dynamic pressure measurement is conducted, based on 23 dynamic pressure sensors mounted on the shroud side casing surface of the compressor. The sensors are circumferentially distributed in a non-uniform manner at seven different radial positions, including the impeller region, the vaneless region and the diffuser throat region. Real-time data is recorded during the whole valve-adjusting process. The characteristics of pressure fields at some specific operating conditions are focused on, especially the pre-stall, stall precursor, stall and surge conditions. According to the multiphase data association, the originating position of the stall precursor can be determined. The features of the unsteady flow structure are also obtained, such as the surge pattern and the propagation direction of stall cells. In addition, when the diffuser vane setting angle (OGV) is turned up, the core factors to trigger total instability will change. In order to visually show how the tip leakage and separation vortex in the impeller gradually affect the flow structure in the vaned diffuser region and even the whole machine, numerical simulation and dynamic mode decomposition (DMD) method are used to study the flow mechanisms. The numerical simulation result is well matched with the experimental result. With the help of the DMD method, a few low-frequency tip leakage vortex structures are extracted from the unsteady numerical result over a period of time, which correlate with the experimental result. Meanwhile, on this issue, the feasibility of dynamic experimental analysis combined with multi-channel numerical simulation analysis is verified and discussed. Through the two analytic methods, a detailed understanding of the unsteady flow structure in the centrifugal compressor with variable vaned diffuser is obtained.

Test and Analysis of Flow Structure in a Furcated Duct

Experimental Study of Flow Structure Characteristics for a T-Junction Duct with Horizontal Vanes

Numerical visualization of flow field in complex passages of periodical fast switch valve

Flow Resistance Characteristics of Self-Repairing Power Law Fluid Flowing in Two-Size, Net-Shaped Ducts

Vortical Flow Development in Round Ducts Across Scales for Engine Inlet Applications

Numerical Computations of the Flow in A Finite Diverging Channel

Flow Development Through an S-Shaped Diffusing Duct

POD and DMD Analysis of Dynamic Flow Structures in the Recirculation Region of an Unconfined Swirl Cup

Numerical Simulation for Effects of Venturi Tube on Swirling Flow Field

Inner–outer Interaction of Unsteady Turbulent Flow Inside Duct with Wall Corrugations: Augmentation and Saturation

Lagrangian Study on Critical Structures During Streamwise Vortex Generation in Open Cavity Flows

Flow Structure of the Entrance of a T-junction Duct Without/with a Circular Cylinder

Direct numerical simulation of a tip-leakage flow in a planar duct with a longitudinal slit

Research On Flow Field Of A Fixed Duct In A Rotary Energy Recovery Device

Experimental and Numerical Analysis of Unsteady Flow Structure in a Centrifugal Compressor with Variable Vaned Diffuser

Test and Improvement of Flow Distribution in A Sudden Changed Structure

Simulation-based Study of Low-Reynolds-number Flow Around a Ventilated Cavity

Effects of Roughness on Fluid Flow Behavior in Ducts

Experimental Investigation of Two Ventilated Cavities with Effect of Froude Number and Gas Entrainment

Probability Density Function of Velocity Fluctuations in a Rectangular T-junction Duct

Numerical Study on Separation Flows of a Compressor Transition Duct