Experimental investigation on steam-water flow patterns in a vertical narrow rectangular channel utilizing conductance scanning measurement
Yiang Yang,Jinbiao Xiong
DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2024.125236
IF: 5.2
2024-02-02
International Journal of Heat and Mass Transfer
Abstract:In order to tackle the challenges in two-phase flow measurement in narrow rectangular channels, especially under pressurized conditions, a novel conductance scanning sensor, consisting of two ceramic-substrate printed circuit (CSPC) boards, has been developed based on the concept of wire mesh sensor. A leak-tight structure was also fabricated to avoid leakage at the penetrations of lead wires through the sensor housing. Measurements have been carried out in a narrow rectangular channel, with inner the cross-sectional dimension 70 mm × 2 mm, under pressure between 0.20 and 0.90 MPa. In the experiment, bubbly, churn and annular flows have been observed, except for slug flow. Flow pattern maps have been proposed for the steam-water two-phase flow. Comparing with those in the literature, it can be found that as the channel width/gap increases, the flow pattern transition boundaries shift towards the higher vapor superficial velocity direction. Additionally, the transition criteria for narrow rectangular channels were investigated by separately evaluating the critical void fraction and the superficial velocity calculation correlations. Results show that the critical void fraction of bubbly to churn flow and churn to annular flow can be approximately estimated as 0.2 and 0.75, respectively. However, the existing correlations for superficial velocity calculation are not suitable for the steam-water flows with a void fraction less than 0.5.
engineering, mechanical,thermodynamics,mechanics