Abstract:By harnessing gasoline’s low reactivity for partially premixed combustion promotion, gasoline compression ignition (GCI) combustion shows the potential to produce markedly improved NOx-soot trade-off with high fuel efficiency compared to conventional diesel combustion. However, at low-load conditions, gasoline’s low reactivity poses challenges to attaining robust combustion with low unburned hydrocarbons (UHC) and carbon monoxide (CO) emissions. Increasing the in-cylinder charge temperature by using variable valve actuation (VVA) can be an effective means to address these challenges. In this numerical investigation, VVA strategies, including (1) early exhaust valve opening (EEVO), (2) positive valve overlap (PVO), and (3) exhaust rebreathe (ExReb), were investigated at 1375 RPM and 2 bar brake mean effective pressure in a heavy-duty GCI engine using a market-based gasoline with a research octane number (RON) of 93. The total residual gas level was kept over 50% to achieve an engine-out NOx target of below 1.5 g/kWh. For a complete engine system analysis, one-dimensional (1-D) system-level modeling and three-dimensional (3-D) computational fluid dynamics (CFD) analysis were close-coupled in this study. Performance of the VVA strategies was compared in terms of in-cylinder charge and exhaust gas temperatures increase versus brake-specific fuel consumption (BSFC). The EEVO strategy demonstrated in-cylinder charge and exhaust temperature increase up to 130 and 180 K, respectively. For similar in-cylinder charge temperature gains, the ExReb strategy demonstrated 11% to 18% lower BSFC compared to the EEVO strategy. This benefit primarily originated from a more efficient gas-exchange process. The PVO strategy, due to the valve–piston contact constraint, required excessive exhaust back-pressure valve (BPV) throttling for hot residuals trapping, thereby incurring higher BSFC compared to ExReb. In addition, the ExReb strategy demonstrated the highest potential for exhaust temperature increase (up to 673 K) among the three strategies. This was achieved by ExReb’s maximum air-fuel ratio reduction from high internal residuals mass and BPV throttling. Finally, the ExReb profile was optimized in terms of the peak lift, the duration, and the location for maximizing the fuel-efficiency potential of the strategy.

Experimental Study on High-load Extension of PODE/Gasoline Dual-fuel RCCI Operation

Experimental study on the high load extension of PODE/methanol RCCI combustion mode with optimized injection strategy

An Experimental Study of the Combustion Process in a Natural-Gas Spark-Ignition Engine

Experimental investigation on n-butanol/methyl oleate dual fuel RCCI combustion in a single cylinder engine at high-load condition

An Efficient Data-Driven Approach for Modeling and Optimization of Reactivity-Controlled Compression Ignition Engine Fueled with Polyoxymethylene Dimethyl Ethers and Hydrogen

Effect of Compression Ratio and Piston Geometry on RCCI Load Limits and Efficiency

Potential of High Load Extension for Gasoline Hcci Engine Using Boosting and Exhaust Gas Recirculation

Extension of the Lower Load Limit in Dieseline Compression Ignition Mode

Load Expansion of a Dieseline Compression Ignition Engine with Multi-Mode Combustion

Numerical Study on Double Injection Techniques in a Gasoline and Biodiesel Fueled RCCI (reactivity Controlled Compression Ignition) Engine

Effects of using argon, hydrogen and syngas on performance and emissions of a heavy-duty natural gas/diesel RCCI engine at low load

Effects of PODE substitution rate and fuel injection timing on combustion, emission characteristic and energy balance in PODE-gasoline dual direct-injection engine

Extending HCCI High Load Operation of Gasoline Engine by Intake Boosting

Experimental study of fuel stratification for HCCI high load extension

Experimental Research on High Load Extension of HCCI Combustion Using Gasoline and Methanol Stratification

Variable Valve Strategy Evaluation for Low-Load Operation in a Heavy-Duty Gasoline Compression Ignition Engine

Experimental investigation on the combustion and emissions in a pilot ignited direct injection natural gas engine using HCDI strategy

Investigations on reactivity controlled compression ignition combustion with different injection strategies using alternative fuels produced from waste resources

Experimental study on wide load operation of gasoline compression ignition engine: Real distillate gasoline versus primary reference fuel

Experimental Study on the Diesel Injection Pressure of Homogeneous Charge Induced Ignition for Multi-cylinder Operation

Experimental study of independent two-stage in-cylinder heat release using jet controlled compression ignition