Abstract:Atomization of low-temperature fuel is encountered in extreme operating conditions of liquid propulsion systems such as cold start and high-altitude relight for aeroengines. Fuel temperature has a great impact on airblast spray characteristics by influencing fuel viscosity and thus the gas–liquid interaction, which raises the demand to clarify the temperature-dependent transition in near-nozzle breakup behavior and the corresponding droplet size distribution. A liquid-centered swirl coaxial injector is tested on the low-temperature swirl spray and combustion test rig at Zhejiang University, using 25 kHz high-speed digital off-axis holography. RP-3 aviation kerosene is atomized under ignition conditions at temperatures of 233, 253, and 301 K, fuel pressures of 0.03 and 0.69 MPa, and air pressure ranging from 0 to 4.0 kPa. Time-resolved near-nozzle dynamics suggest four types of elementary breakup processes: wavy-sheet breakup, pulsating breakup, membrane-type breakup, and nonaxisymmetric Rayleigh breakup. Each process alternately dominates the near field as fuel Reynolds number (Ref) and aerodynamic Weber number (Weg) decrease, corresponding to four primary breakup modes. A mode classification plot is summarized. Spray structures show an extended breakup length and reduced spray cone angle as fuel temperature (Tf) decreases. Increasing air pressure (Pg) promotes spray expansion at 0.03 MPa, but contracts spray cone at 0.69 MPa. Cross-sectional Sauter mean diameter (SMD) distribution indicates a solid-cone spray at 0.03 MPa and a hollow cone spray at 0.69 MPa. Lowering Tf will rise the SMD in the spray center at 0.03 MPa and transform the toroidal SMD distribution at 0.69 MPa into a solid one. Finally, a temperature-related SMD model is derived considering the exponential viscosity–temperature relationship, and a good fit with R2 > 0.95 is achieved. This research aims to deepen the understanding of the effects of low temperature on the transition of near-nozzle atomization characteristics for airblast sprays. Both spray visualization and SMD results provide reference for numerical simulations and near-nozzle spray modeling.

Investigation of Secondary Breakup Mechanism of Flash-boiling Spray Based on Experiments of Single Droplet

Quantitative Observation on Characteristics and Breakup of Single Superheated Droplet

Atomization and vaporization for flash-boiling multi-hole sprays with alcohol fuels

Droplet Evaporation to Boiling in Van Der Waals Fluid

Mechanism of flash boiling bubble breakup based on rim-like structure

Experimental Investigations of the Phase Change Impacts on Flash Boiling Spray Propagations and Impingements

Quantitative Study on the Influence of Bubble Explosion on Evaporation Characteristics of Flash Boiling Spray Using UV-LAS Technique

The Effect of Bubbles on Primary Breakup of Diesel Spray

Microscopic investigation of near-field spray characteristics of 2-methylfuran, ethanol and isooctane under flash boiling conditions

Experimental Study of Flash Boiling Spray Vaporization Through Quantitative Vapor Concentration and Liquid Temperature Measurements

INVESTIGATION OF RAPID ATOMIZATION AND COLLAPSE OF SUPERHEATED LIQUID FUEL SPRAY UNDER SUPERHEATED CONDITIONS

Evaporation and Atomization Characteristics of Dual-Fuel System under Flash Boiling Conditions

Experimental Characterization of Closely Coupled Split Isooctane Sprays under Flash Boiling Conditions

Thermal Nonequilibrium and Mechanical Forces Induced Breakup and Droplet Formation of Superheated Liquid Jets under Depressurized Release

Characteristics and Correlation of Nozzle Internal Flow and Jet Breakup under Flash Boiling Conditions

Effects of Low Temperature on Near-Nozzle Breakup and Droplet Size Distribution in Airblast Kerosene Spray

Experimental study on the secondary droplet formation mechanism when droplet impacting on superheated surface

Experimental Characteristics of Viscous Fluid Secondary Breakup

Dynamic characteristics of in-nozzle flash boiling bubbles and corresponding temporal responses of external spray

An Experimental Investigation on the Secondary Breakup of Carboxymethyl Cellulose Droplets

Investigation on flash boiling spray fluctuations in the near-field and far-field under gasoline direct injection related conditions