Abstract:Superheated droplets vaporized in a vacuum or vapor chamber was studied using smoothed particle hydrodynamics method.The two-phase fluids of vapor and liquid with a diffused interface were modeled by Navier-Stokes-Korteweg equations,with the van der Waals equation of state.The liquid-vapor separation was processed with different initial temperature and density.Simulation was firstly validated by the proper equilibrium states with analytical data from the binodal line of Maxwell construction,as well as the droplet surface tension compared with experimental and other groups'numerical data in a good agreement.Droplet morphology,density,temperature and entropy increment were then carefully examined during the dynamic process from evaporation to boiling.Four phase transitions patterns were concluded,namely from surface evaporation,internal bubble,fragment and explosion,to flash boiling with increasing equivalent superheat degree that is defined by the non-dimensional superheat temperature over surface tension.Results showed that droplet temperature and density decreased slightly at surface evaporation when equivalent superheat degree was lower than 1/3.Above this criterion,the internal bubble could be sustained.Growth of new liquid nucleates and connected secondary liquid ring were calculated by domain growth theory.We found that droplet continuous to expand at high superheat but withdrawn at equivalent superheat degree equal to or lower than 0.52.At equivalent superheat degree higher than 1,the growth and expansion of droplet resulted in liquid fragment and explosion to many small secondary droplets.Mean mass and diameter of these droplets were found to have power-law dependency on the expansion rate.Finally,fast flash boiling occurred at equivalent superheat degree higher than 3.The vapor pressure in the chamber showed a negative linear correlation between the overpressure and the atmospheric pressure.We also found out that comparing to increase the pressure value,dense gas had better efficiency on retarding the propagation of shock wave.

Quantitative Study on the Influence of Bubble Explosion on Evaporation Characteristics of Flash Boiling Spray Using UV-LAS Technique

Quantitative Observation on Characteristics and Breakup of Single Superheated Droplet

Droplet Evaporation to Boiling in Van Der Waals Fluid

Investigation on cavitation enhancement on flash boiling atomization using two-dimensional slit nozzles

An Experiment Study on Flash Boiling Spray

Experimental and numerical simulation study on the mass transfer characteristics of static flash evaporation

A morphological study of supercritical fuel flash-boiling spray

Quantitative observation on breakup of superheated liquid jet using transparent slit nozzle

Experimental Characterization of Closely Coupled Split Isooctane Sprays under Flash Boiling Conditions

Impacts of flash boiling plume interactions on atomization evaluated using two-dimensional optical slit nozzles

Experimental studies of droplet nucleate boiling characteristics on micro-cavities surfaces with different wettability

Correlation Analysis of Superheated Liquid Jet Breakup to Bubble Formation in a Transparent Slit Nozzle

Droplet boiling on heated surfaces with various wettabilities

The Influence of Flash Boiling Conditions on Spray Characteristics with Closely Coupled Split Injection Strategy

Study on Water Droplet Flash Evaporation in Vacuum Spray Cooling

Thermal Nonequilibrium and Mechanical Forces Induced Breakup and Droplet Formation of Superheated Liquid Jets under Depressurized Release

Experimental study of the macroscopic characteristics of methanol low-pressure injection spray

Vaporization dynamics of a super-heated water-in-oil droplet: modeling and numerical solution

Visualization and quantitative study on film boiling heat transfer of a salt droplet on the hydrophobic substrate

Evaporation Characterization Of Fuel Spray Impinging On A Flat Wall By Laser-Based Measurement

Experimental Investigation of Boiling of Droplets on Heated Surfaces