Abstract:In gas turbines, the stator wells play a key role in the efficiency of the turbomachine. The research for performance gains requires a good understanding and an accurate modeling of the flows and heat transfers occurring in these areas. Within the framework of the European program main annulus gas path interaction (MAGPI) WP1, a two-stage axial turbine test rig provided an experimental database used to validate the computational fluid dynamics (CFD) models. The aim of this study is to setup a numerical methodology using the CFD solver ANSYS Fluent to accurately predict the conjugate heat transfer in the stator well area. The validation of the methodology relies on thorough comparison of the results with the MAGPI WP1 experimental temperature/pressure measurements. A geometry with axial cooling injection through lock plate slot was chosen. A Reynolds-averaged Navier–Stokes (RANS) three-dimensional sectorized CFD model of the turbine with conjugate heat transfer was used. It includes main gas path, cavities with labyrinths, disks rotor, the casing, and the nozzle guide vanes (NGV). Mixing planes are placed between the static and rotating frames. Different influences (mesh, turbulence model, thermal boundary conditions, radial labyrinths clearances) were studied and compared with experimental data. As a baseline, the first calculations were performed with a cooling flowrate chosen so that hot gas ingresses from the main stream into the stator well cavity. Good agreements between predicted and measured temperatures/pressures were observed, especially in the vicinity of the stator well. Discrepancies were spotted at the first rotor hub endwall and at the upstream wheelspace and will be discussed. Two other cooling configurations were conducted, one with cooling air exiting from the disk rim cavity to the main gas path and the other with the lowest cooling flowrate and so the highest ingress. Finally, the turbine performance under nonadiabatic conditions has been evaluated with an appropriate efficiency definition.

Numerical Investigations on Unsteady Flow Excitation of Long Blade Turbine Stage

Large Eddy Simulation and CDNS Investigation of T106C Low-Pressure Turbine

Les and Cdns Investigation of T106c Low Pressure Turbine

NUMERICAL INVESTIGATION OF STATOR CLOCKING EFFECTS ON THE DOWNSTREAM STATOR IN A 1.5-STAGE AXIAL TURBINE

Flow Computations of Multi-Stages by URANS and Flux Balanced Mixing Models

Numerical simulation of internal flow in forward-curved centrifugal fan

Unsteady 3D-Numerical Investigation of the Influence of the Blading Design on the Stator-Rotor Interaction in a 2-Stage Turbine

ANALYSIS ON FLOW SEPARATION CHARACTERISTICS OF LAST STAGE BLADE IN STEAM TURBINE UNDER SMALL VOLUME FLOW CONDITION

The Effect of High-Speed Steam Discharged from the Bypass Diffusers on Low-Pressure Turbine Blades

Analysis on strength performance of the last stage blade in steam turbine under low mass flow conditions

Structure and Modal Analysis of the Last Stage Blade in Steam Turbine under Low Volume Flow Conditions

Numerical Investigation Of Pressure Fluctuation And Rotor-Stator Interaction In A Multistage Centrifugal Pump

High-fidelity simulations of a high-pressure turbine stage: effects of Reynolds number and inlet turbulence

3D Numerical Investigation on the Aerodynamic Performance of an Air Cooled 4-Stage Turbine

A Study and Optimization of the Unsteady Flow Characteristics in the Last Stage Impeller of a Small-Scale Multi-Stage Hydraulic Turbine

Numerical Simulation Against Unsteady Flow from Cavity Leakage of Turbomachinery Stage

Blade Excitation Related Flow Behavior Analysis on the Turbocharger’s Centrifugal Compressor with Volute and Casing Treatment

Numerical Simulation of Turbine Stage with Cooling Gas Injection

Numerical Investigations of Flows and Heat Transfer in Turbine Disk Cavities

Numerical simulation of unsteady single-stage transonic axial compressor flow

THREE DIMENSIONAL VISCOUS FLOW NUMERICAL ANALYSIS OF STALL FLUTTER IN STEAM TURBINE BLADES