Abstract:Recent years have seen increased interest in dedicated exhaust gas recirculation (D-EGR) systems integrated with reciprocating engines. By dedicating one cylinder to operate at fuel rich conditions, hydrogen is generated for use in the remaining cylinders to optimize combustion and mitigate pollutant emissions. In this study, experiments were performed using a rapid compression machine (RCM) to investigate the effects of hydrogen and carbon monoxide on methane ignition and flame propagation at fuel rich and stoichiometric conditions relevant to D-EGR engines. The experiments were conducted over a range of temperatures (T = 860–1080 K) and equivalence ratios (ϕ = 1.0–1.5) and at a pressure of P = 20 atm. The results showed hydrogen addition had little effect on ignition delay time at lower temperatures (T < 950 K), but hydrogen significantly promoted ignition at higher temperatures (T > 950 K). Carbon monoxide had little effect on ignition delay times at all conditions studied. Combustion products were acquired using a fast sampling system and analyzed using gas chromatography. The results showed at ϕ = 1.4 the hydrogen mole fraction was a maximum of 8.0% of the products of rich combustion which was consistent with predictions based on chemical equilibrium calculations and model simulation results. High speed images were taken to quantify the impact of equivalence ratio on flame speed for spark-ignited mixtures in RCM experiments using mixtures similar to those expected in the D-EGR and stoichiometric cylinders. The results indicated the H2 in the D-EGR promoted the combustion process in the stoichiometric cylinder, increasing flame speed and decreasing combustion duration. Specifically, when the equivalence ratio in the D-EGR cylinder was ϕ = 1.3, the flame speed increased by about 40% compared with ϕ = 1.0. However, higher equivalence ratios reduced the flame speed and thus adversely affected combustion in the D-EGR cylinder. The results indicate stability and effectiveness of the combustion in the D-EGR cylinder could be a major concern for D-EGR natural gas engines, and optimizing the equivalence ratio of the D-EGR cylinder is critical for D-EGR to enhance combustion performance in the engine overall.

Study on Combustion Characteristics of Dimethyl Ether and Hydrogen Blends Based on a Rapid Compression Machine

Autoignition of DME/H2 mixtures in a rapid compression machine under low-to-medium temperature ranges

Effect of Pressure and Equivalence Ratio on the Ignition Characteristics of Dimethyl Ether-Hydrogen Mixtures

Experimental and Kinetic Study on Ignition Delay Times of DME/H2/O2/Ar Mixtures

Ignition Properties of Lean DME/H-2 Mixtures at Low Temperatures and Elevated Pressures

Experimental And Kinetic Studies On Ignition Delay Times Of Dimethyl Ether/N-Butane/O-2/Ar Mixtures

Experimental and Modeling Study on Ignition Delay Times of Dimethyl Ether/n-Butane Blends at a Pressure of 2.0 MPa

PREMIXED IGNITION CHARACTERISTICS OF BLENDS OF GASOLINE AND DIESEL-LIKE FUELS ON A RAPID COMPRESSION MACHINE

Effects of Equivalence Ratio and Blending Ratio on the Ignition Delays of N-Pentane/hydrogen Mixtures under Engine Relevant Pressure

Experimental Study on Premixed Combustion of Dimethyl Ether-Hydrogen-Air Mixtures

Study on the Effect of Hydrogen Addition to Dimethyl Ether Homogeneous Charge Compression Ignition Combustion Engine

Experimental and numerical study on the ignition delay times of dimethyl ether/propane mixtures in O2/CO2 atmospheres

Experimental and Modeling Study on Ignition Delay Times of Dimethyl Ether/Propane/Oxygen/Argon Mixtures at 20 Bar

Experimental and Numerical Study on the Ignition Delay Times of Dimethyl Ether/ethane/oxygen/carbon Dioxide Mixtures

Experimental and Simulated Study on the Ignition Delay Time of Dimethyl Ether/n-Heptane/oxygen/argon Mixtures

Experimental and Modeling Study on Ignition Delay Times of Dimethoxy Methane/n-Heptane Blends

Ignition Characteristics of Dual-Fuel Methane-N-hexane-oxygen-diluent Mixtures in a Rapid Compression Machine and a Shock Tube

Experimental and Kinetic Study on Ignition Delay Times of Dimethyl Ether at High Temperatures

Ignition Delay Characteristics and Kinetic Investigation of Dimethyl Ether/n-Pentane Binary Mixtures: Interpreting the Effect of the Equivalence Ratio and Dimethyl Ether Blending

Measurements and Kinetic Study on the Ignition Delay Time of Dimethyl Carbonate/n-Heptane/oxygen/argon Mixtures

A Rapid Compression Machine Study of Autoignition, Spark-Ignition and Flame Propagation Characteristics of H2/CH4/CO/air Mixtures