Abstract:Numerical investigations of combined impingement and film cooling based on different turbulence models have been carried out and compared in the present study. The specific test case combines the complex flow physics of the jet impinging, turning and subsequent mixing with hot mainstream, which consists of jet shear layer separation, wall boundary layer transition, coolant jet detachment and reattachment. The turbulence models employed are the k  − standard, RNG, and realizable models, the k − standard, SST, and Transition SST models, and the t l k − k − model. Numerical tests have been performed at three representative blowing ratios from low to high for each turbulence model. The computed cooling effectiveness from  equation models tend to be underpredicted at low blowing ratio while numerical profiles of cooling effectiveness achieve considerable agreement with the measured experiment data at moderate and high blowing ratios. In addition, the computed results from  equation models reasonably match the measured data at low blowing ratio but cooling effectiveness are markedly underpredicted at moderate and high blowing ratios. In contrast, those results from the t l k − k − model agree fairly well with those of the experiment at various blowing ratios. Owing to the nature description of the pre-transitional streamwise fluctuations in the laminar kinetic energy, the solutions from t l k − k − model clearly reveal the complex flow physics in the combined impinging and film cooling in the confined region, where the jet shear layer separation, boundary layer transition, coolant detachment and reattachment co-exist. However, the large number of specified parameters in the t l k − k − model still needs to be further optimized to reach the enhanced agreement with experimental data and obtain extensive applications for combined cooling schemes.

Numerical Study on Array Air Jet Heat Transfer Uniformity

Effects of Nozzle Arrangement on Uniformity of Multiple Impinging Jets Heat Transfer in a Fast Cooling Simulation Device

Numerical Study of Impinging Jets Heat Transfer with Different Nozzle Geometries and Arrangements for a Ground Fast Cooling Simulation Device

Numerical Study on Heat Transfer Characteristics of Jet Array Impingement

Numerical Study On Flow And Heat Transfer Characteristics Of Jet Impingement

Comparative Study Of Impinging Jet Array Heat Transfer On A Flat Plate Cooled By Superheated Steam And Air

Numerical Study on Flow and Heat Transfer Characteristics of 3D Turbulent Impinging Jets

Effect of the Nozzle Geometry on Flow Field and Heat Transfer in Annular Jet Impingement

Numerical Study of the Flow and Heat Transfer of a Rectangular-tube Turbulent Impinging Jet Flow

Heat Transfer Characteristics Research of Screw Thread Swirling Impinging Jets Based on Numerical Simulation Method

Numerical investigation on heat transfer enhancement and surface temperature non-uniformity improvement of spray cooling

Numerical Study and Structural Optimization of Impinging Jet Heat Transfer Performance of Floatation Nozzle

A developed transition simulation model for turbulent plane jet impingement heat transfer

Numerical Study on Stagnation Point Heat Transfer by Jet Impingement in A Confined Narrow Gap

NUMERICAL INVESTIGATION OF DIFFERENT TURBULENCE MODELS APPLIED IN COMBINED IMPINGEMENT AND FILM COOLING

Numerical Study on Heat Transfer by Swirling Impinging Jets Issuing from a Screw-Thread Nozzle

Experimental Study on Cooling Performance of Multiple Impinging Jets with Different Nozzle Arrangements in a Ground Fast Cooling Simulation Device

Numerical investigation on the heat transfer performance of array jet impingement cooling with sinusoidal-corrugated target plate

Experimental Investigation of Local and Average Heat Transfer Coefficients under an Inline Impinging Jet Array, Including Jets with Low Impingement Distance and Inclined Angle

Numerical Analysis of Turbulent Round Jet Impingement Heat Transfer at High Temperature Difference

Numerical Investigation of Heat Transfer Characteristics of Impinging Synthetic Jets with Different Waveforms