Abstract:In this paper, a model of flood area display and damageevaluation is discussed, which adopts seed spread algorithm to calculate and visualize flood area based on a DEM data set and under the condition of a given water level of flood. The raster image containing flood area is overlaid with raster data converted from thematic vector maps such as land-use map and related to other socio-economic data, and then quantitative evaluation of flood damage is achieved. There are two different cases, the so-called “non-source flood” and “source flood”, for determining flood area based on DEM and under the given water level condition. Non-source flood corresponds to the case with well-distributed and large-area rainfall where all the low-lying land may have a flood disaster, and in this case all the points with elevations below the given water level should be included in the flood area. The “source flood” is the case of flood (e.g. from bank burst) flushing through the surrounding lands that needs to consider “ci rculating” condition. Because flood may be obstructed by ring structures or high lands, thus it can only cover the place where it flows and reaches. One of the computer processing methods suitable for source flood is the seed-spread algorithm. The principle of this method is to select a representative pixel as a seed and to examine its contiguous pixels outward along 4 or 8 directions. The pixels, contiguous to it and meeting the given conditions, become seeds, and then contiguous pixels to the new seeds will be examined in the same way. This process repeats until an aggregation of the pixels which meet the given conditions on a certain plane are obtained. Adopting seed spread algorithm for source-flood area calculation is just to achieve an aggregation of pixels, which satisfies the connectivity requirement and the given conditions of water level. The initial position of seed pixel should usually be selected on the characteristic points, e.g. adjacent to a reservoir dam or stream boundary. The precision of flood area calculation is mainly determined by spatial resolution of the DEM, the area on the ground is represented by each pixel; whereas the accuracy of flood area calculation, to a great extent, is dependent on the preci sion of the DEM's pixel value or elevation.Once the area below the flood water level has been calculated, the flood damage evaluation can be calculated by overlaying the flood range with thematic maps and by relating to other socio-economic data. All thematic maps were converted to raster data because algorithm of the overlay analysis implemented in raster format is relatively simple and computing is fast. In order to improve accuracy of the flood damage evaluation it is necessary to accurately register and georefer all raster layers before overlay analysis. The calculation results of flood damage evaluation are generally represented by tabulation, which is a kind of classified statistics of flood damage data, e.g. a table representing total area of every land-use type in different administrative divisions. The results of flood area calculation and damage evaluation can also be visually and dynamically provided in the forms of graph, image, 3D or virtual reality. The model has been successfully applied in the “Zhejiang Provincial Water Conservancy Management System” developed for a national project.

Risk Evaluation Model of Reservoir Flood Control Based on Sampling Rank Correlated Random Variables

Estimating Uncertainty in Design Flood for Ungauged Catchments

Urban Flood Risk Assessment Using Storm Characteristic Parameters Sensitive to Catchment-Specific Drainage System

Efficient joint probability analysis of flood risk

Multi-objective risk analysis for flood control operation of a complex reservoir system under multiple time-space correlated uncertainties

Risk Analysis of Dynamic Water Level Setting of Reservoir in Flood Season Based on Multi-index

Study on flood control risk of flood control engineering system based on the clustering of measured data

Risk analysis of reservoir floodwater utilization coupling meteorological and hydrological uncertainties

An accuracy-improved flood risk and ecological risk assessment in an interconnected river–lake system based on a copula-coupled hydrodynamic risk assessment model

Risk analysis for the multi-reservoir flood control operation considering model structure and hydrological uncertainties

Extreme Risk Analysis on Adjusting Flood Control Level of Reservoirs in Water Shortage Area of Northern China

Risk analysis for reservoir flood control operation considering two-dimensional uncertainties based on Bayesian network

Review of Risk Analysis on Flood

Risk Assessment of Coal Mine Flood Disasters Based on Projection Pursuit Clustering Model

Extreme Risk Analysis under Uncertainty of Design Flood

A GIS Based Model for Calculating of Flood Area

A GIS-based Method for Flooded Area Calculation and Damage Evaluation

Study on Flood-Water Resources Utilization by Raising Up the Flood Control Level

Integrated real-time flood risk identification, analysis, and diagnosis model framework for a multireservoir system considering temporally and spatially dependent forecast uncertainties

Comparative Study of Flood Coincidence Risk Estimation Methods in the Mainstream and its Tributaries

Rank classification method for cascade reservoirs considering scale, benefits, and risk consequences