Experimental Study of the Fluid-rock Interactions between CO2-rich Fluid and Sandstone and Its Application:A Case Study of the Upper Permian Longtan Formation in the Huangqiao Oil and Gas Reserviors

Qingqing REN,Wenxuan HU,Xiaolin Wang,Hao YU,Suping YAO,Xiaoyu WANG,Yuexia ZHANG,Zailian XIA

DOI: https://doi.org/10.16108/j.issn1006-7493.2016151

2017-01-01

Abstract:The Huangqiao oil and gas field in eastern China is unique at the coexistence of CO2 and hydrocarbon accumulations and the production of oil CO2 and sandstone reservoir quality vary largely between wells.CO2-rich fluid has substantial reformation of the reservoir.Based on these backgrounds,a set of interaction experiments within the CO2-formation water-sandstone system is conducted in closed containers from 60 ℃ to 120 ℃ and from 10MPa to 40 MPa,which correspond to the burial depth from 1500m to 4000 m.The objective is to understand the corrosion of CO2-rich fluid on the sandstone reservoir.Analytical results show that the corrosion is apparent,the corrosion mineral is mainly carbonate,and the corrosion has reached equilibrium in the solution after 72 hours.Then,the ion concentration of Ca in the equilibrium solution is two orders of magnitude higher than the other ions.The corrosion intensity has negative and positive correlations with temperature and pressure,respectively,and the pressure is the primary control.Pressure contols the solubility of CO2 in the solution,and has particular corrosion ability at relatively high temperatures.In contrast,feldspars are corroded only a little because they have not reached equilibrium.Based on the regional geology,we infer that the CO2 is derived mainly from mantle along deep-seated faults.The CO2-rich fluid migrated into the Longtan Formation sandstone along the faults,and was overburdened by extremely thick fine-grained clastics.As a consequence,a relatively closed fluid-rock interaction system with high temperature and pressure was formed.The fluid-rock interaction was strong near faults and thus the reservoir corrosion and reformation was significant,leading to great amounts of secondary pores (e.g.in the Xi 3 well).In contrast,the fluid-rock interaction was relatively weak far from faults and thus the fluid-rock interaction and the development of secondary pores were relatively weak (e.g.in the Xi 2 well).Therefore,we propose a fault-controlled model of CO2-rich fluid-rock interaction as the main mechanism controlling the physical properties of the Longtan sandstone reservoir in the study area.