Motion characteristics of coarse particles in guide vanes of lifting pump for deep-sea mining

Rongchang LUO,Shuqi YU,Jianxin XIA,Bin CAO

DOI: https://doi.org/10.16483/j.issn.1005-9865.2017.04.015

2017-01-01

Abstract:As the key equipment in deep-sea mining system, the lifting pump' s design parameters play an important role in safe and efficient ore-conveying. In this research, the force equations and kinematic equations were established based on the analysis of the stress of solid particles. Furthermore, the motion characteristics of coarse particles in guide vanes were studied with different structure parameters and transmit parameters. The results are as follows: ( a ) Under the condition of a certain particle size, when the inlet-guide-vane angle (θ) is in the range of 15°~20° , the collision between particles and the guide vanes occurrs at a faster speed in a shorter time, as compared with 25° and 30° of the inlet-guide-vane angle. This would lead to more serious wear for the guide vane. However, when θ is over 25°, the resistance of the particle pump is increased due to overbend guide-vane surface. Therefore, the optimalθis 25° in this experiment. ( b) When the runner width is less than 3dmax , the collision position is closer to the guide vane inlet and the collision speed also becomes faster. When the runner width is over 3dmax , the guide-flow capability of the guide vane is reduced. So, the optimal runner width is 3dmax . ( c) With the flow velocity increase, collision speed becomes faster and the wear for the guide vane is more serious. ( d) At the same flow velocity, the residence time for particles would be prolonged along with the increase of particle size. What is more, the blocking probability of pump will increase.