The stress evolution of H96 brass double-ridged rectangular tube in rotary draw bending

Honglie Zhang,Yuli Liu,He Yang

2015-01-01

Abstract:The cross sectional deformation of DRRTs occurs easily in rotary draw bending ,which largely restricts the improve‐ment of bending quality and forming limit .The cross sectional deformation of a tube enormously depends on its stress state ,so it is benefit to enhance the knowledge of deformation mechanism by studying the stress variation and then it is helpfnl to develop method for decreasing cross sectional deformation .Based on the platform of ABAQUS/Explicit ,a three‐dimensional finite ele‐ment model of DRRT in rotary draw bending was established and its reliability was validated by experiment .Dividing the bended portion of DRRT into two zones ,MSZ(mandrel support zone) and NMSZ(no mandrel support zone) ,variation laws of equivalent stress ,tangent stress and circumferential stress at the feature points B1‐B4 on the symmetric lines of flanges and ridge grooves of DRRT were studied with the aid of this model .The results show that when the section is located in the MSZ ,the equivalent stress ,tangent stress and circumferential stress of B1 and B2 fluctuate on different levels .The similar phenomenon does not occur for the stresses of B3 and B4 ,but the tangent stress and circumferential stress of B3 generate reverse loading phenomenon .When the section lies in the NMSZ ,the stresses change gently .