Abstract:The mandrel plays a vital role in metal tube bending limit improvement and high-quality achievement. For the bending forming process of metal tubes with different diameters, the corresponding mandrel needs to be customized, which has the disadvantages of a long design cycle, high manufacturing cost, and low reuse rate. Therefore, a novelty concept of diameter adjustable mandrel (DAM) based on the multi-point contact was proposed to adapt different diameter tube bending processes. Since the point-contact characteristics of the DAM can lead to irregular cross-section deformation, the cross-sectional full profile radial error (FP-RE) model was proposed. As a more comprehensive evaluation model, the FP-RE model is used to measure the deformation degree of the whole bending cross-section. A diameter-adjustable DAM was adopted in the AISI 304L tubes (the inner diameter = 40–56 mm) bending experiments. The maximum absolute error of FP-RE was 0.11% compared with the ones obtained from FEA in Abaqus/explicit. In addition, the effects of the DAM characteristic parameters, viz., the support blocks amount, the effective magnification, and the effective support diameter, on the tube forming quality were discussed. The results indicated that (a) an even number of support blocks could prevent the collapse of the outer convex tube wall and improve the quality of the inner concave tube wall. (b) When the DAM was used in the larger inner diameter tube bending, the larger non-contact area would cause an increase in the roundness section distortion. (c) A larger DAM diameter would lead to a more minor cross-section deformation degree for the tubes with the same diameter, while the wall thinning was just the opposite. Finally, the result also proved that the DAM (the minimum effective diameter is 40 mm with six support blocks) could be used for tubes with an inner diameter of about 40–56 mm, and the forming quality was acceptable.

An Innovative PVC Mandrel for Controlling the Cross-Sectional Deformation of Double-Ridged Rectangular Tube in Rotary Draw Bending

Reverse Deformation Design for Bending Control in Welding of Ring Stiffeners

Investigation of Angular Deformation Control for T-joint Rib Using Multi-Point Constraint Method

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

A novelty mandrel supported thin-wall tube bending cross-section quality analysis: a diameter-adjustable multi-point contact mandrel

Insight into deformation allocation in the multi-pass roll forming of a double-walled brazed tube

A Comparison of Internal Mandrel Designs for Rotary Draw Bend Forming of Carbon-fibre/Thermoplastic (PA6) Tubular Structures

Novel flexible cores in rotary draw bending forming: applied for the commercial vehicle anti-collision beam with rectangular ribbed (日-shaped) section

A New Bionic Elastic Mandrel for Application in the Spatial Consecutive RDB with no Straight Line

Research on plastic deformation law and forming technology of rotary forging with multi-cone rolls

Analysis and Control of Cracking and Wrinkling at the End of Seamless Steel Tube with Multi-Pass Large Deformation Diameter-Reducing

Investigation on formability of ribbed tube and its forming quality by MPCD process

Experimental Study on Rotary Draw Bending of Magnesium Alloy Extruded Tubes

Effect of cold process drawing parameters on the formability and microstructure of ribbed cladding tubes

Rotary forging with multi-cone rolls

Uncertainty analysis and robust design optimization for the heat-assisted bending of high-strength titanium tube

Numerical and experimental investigation on precision forming of ribbed tube by cold drawing process

The influence of multi-point roller-dies on the shape deviation differences of profile in flexible stretch-bending forming

Investigation on the influence of mandrel on the forming quality of thin-walled tube during free bending process

Full-Cross-Section Deformation Characterization of Cu/Al Bimetallic Tubes under Rotary-Draw-Bending Based on Physics-Driven B-Spline Curves Fitting

Effect of multi-point roller dies on the forming accuracy of profile in flexible 3D stretch bending technology