Assessment on the Features of Physical Load in Moulding Workers

LEI Ling,XIAO Guo-bing,XU Jian-guo,WU Yu-xia,GE Lin-na,LIANG You-xin
DOI: https://doi.org/10.3969/j.issn.1002-221x.2005.06.001
2005-01-01
Abstract:Objective To analyze the physical load characteristics of moulding workers by combining posture observation and surface electromyography(sEMG).Method Using Ovako working posture analysis system(OWAS),(5 074) persons/times working postures in moulding workers were observed,meanwhile,the surface myoelectric potentials of 4 pairs of trunk muscles such as the variability,concordance,symmetry and some typical myoelectric activities during 5 different working postures were also analyzed by sEMG.Result The observation on working postures showed that nearly 87.7% were un-upright,14.7% were hip-twisting postures among them;13.2% of the working time received 10 kg or more loads;and 55.2% of working postures were produced by manual work including shoveling,pressing,lifting,pushing and pulling etc.The sEMG showed quite small variabilities and higher asymmetries(60%);compared with other trunk muscles,the myoelectric activities of erector spinal muscles were the highest one with an average potential that might be over 20% MVC and even reached 50% MVC during some typical motions.Conclusion It may be concluded as that the poor coordination of trunk muscles,overstrain of erector spinal muscles and asymmetrical exertion are the main characteristics of moulding workers,which may be related to the high prevalence of low back pain in these workers.
What problem does this paper attempt to address?